PlainRecalls
No agency classActive

CPSC recall · Reported June 19, 2001

CPSC, Fluke Corp. Announce Recall of Electrical Testers

The recalled units can "lock-up" and stop working. When the tester "locks-up" it stops working for approximately 8 minutes without warning. Consumers testing electrical sources co…

Recall #
01515
Affected scope
Approximately 33,000
Verify with CPSC →
View my saved recalls

Fluke Corp., of Everett, Wash. recalled The model T-2 hand-held electrical voltage and continuity testers measure 24 to 600 volts….

CPSC, Fluke Corp. Announce Recall of Electrical Testers was recalled by Fluke Corp., of Everett, Wash. in June 19, 2001. Reason: The recalled units can "lock-up" and stop working. When the tester "locks-up" it stops working for approximat…. Remedy: Consumers should stop using these voltage and continuity testers immediately, and contact…. Verify recall #01515 with the CPSC before acting.

The recall

Fluke Corp., of Everett, Wash. issued this CPSC recall-The recalled units can "lock-up" and stop working. When the tester "locks-up" it stops working for approximat….

None
agency class
June 19, 2001
reported

Sourced from official CPSC enforcement records. Verify recall #01515 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Household Products recalls over time

Where this recall sits in its category - 3,089 household products recalls on record

50100150200250 20052008201120142017202020232026 148

Product description

The model T-2 hand-held electrical voltage and continuity testers measure 24 to 600 volts alternating current (VAC), and 6 to 220 volts direct current (VDC). "Fluke" and "T2" are written on the front of the unit. The tester body is yellow and black, and measures about 6.25 inches long by 1.75 inches wide and 1.25 inches thick. The wire leads are black and have one black and one red probe. Recalled units have a serial number higher than 73510000. The serial number is located on the back of the unit above the wire leads. Fluke conducted two previous recalls in November 1998 and 1999 on T2 Electrical Testers because of different electrical connection problems. Even if consumers had their testers repaired previously (serial numbers below 74165430), their testers could be part of this new recall and the serial number must be checked to determine if it is included in this recall program.

Reason for recall

The recalled units can "lock-up" and stop working. When the tester "locks-up" it stops working for approximately 8 minutes without warning. Consumers testing electrical sources could fail to be warned of the presence of live current if the tester is not properly operating, posing a risk of shock, electrocution, and thermal burns.

Remedy, what to do

Consumers should stop using these voltage and continuity testers immediately, and contact Fluke for information on returning the recalled unit to Fluke for a free repair. Fluke has sent direct notice to known purchasers.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 01515
Date reported June 19, 2001
Date initiated June 19, 2001
Recalling firm Fluke Corp., of Everett, Wash.
Affected scope Approximately 33,000
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should stop using these voltage and continuity testers immediately, and contact Fluke for information on returning the …

  • Check the recall number (01515) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
The model T-2 hand-held electrical voltage and continuity testers measure 24 to 600 volts alternating current (VAC), and 6 to 220 volts direct current (VDC). "Fluke" and "T2" are written on the front of the unit. The tester body is yellow and black, and measures about 6.25 inches long by 1.75 inches wide and 1.25 inches thick. The wire leads are black and have one black and one red probe. Recalled units have a serial number higher than 73510000. The serial number is located on the back of the unit above the wire leads. Fluke conducted two previous recalls in November 1998 and 1999 on T2 Electrical Testers because of different electrical connection problems. Even if consumers had their testers repaired previously (serial numbers below 74165430), their testers could be part of this new recall and the serial number must be checked to determine if it is included in this recall program.. Recalled by Fluke Corp., of Everett, Wash.. Units affected: Approximately 33,000.
Why was this product recalled?
The recalled units can "lock-up" and stop working. When the tester "locks-up" it stops working for approximately 8 minutes without warning. Consumers testing electrical sources could fail to be warned of the presence of live current if the tester is not properly operating, posing a risk of shock, electrocution, and thermal burns.
What should consumers do?
Consumers should stop using these voltage and continuity testers immediately, and contact Fluke for information on returning the recalled unit to Fluke for a free repair. Fluke has sent direct notice to known purchasers.
Which agency issued this recall?
This recall was issued by the CPSC on June 19, 2001. CPSC does not publish a hazard classification for this recall. Recall number: 01515.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with CCM Hockey U.S. Recalls FMHVR Hybrid Visors and ACCHVR Repl… → · All Household Products recalls

This recall: CPSC, reported June 19, 2001. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026