CPSC, Adams Manufacturing Corp. Announce Recall of Folding Chair

Recall Insight

This CPSC action (record #02223) was formally reported on August 7, 2002. It is classified under Moderate severity, with a current status of Active. Adams Manufacturing Corp., of Portersville, Pa. is listed as the recalling firm. Federal records indicate About 2,740 units are affected.

The documented reason for this recall is: Some of the legs on these chairs were mis-assembled by the installer and a piece of the chair could be bent out of shape. This can allow the chair to collapse during use, causing consumers to suffer injuries from falls. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the folding chairs immediately and return them to the place where purchased to receive a replacement chair or a refund. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 24 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.