Severity
Moderate
CPSC recall · Reported October 2, 2002
A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spread of smoke, fire and fumes. The recalled actuators can jam and preve…
Invensys Building Systems, of Love Park, Ill. recalled Actuators hold open fire and smoke dampers in a building's heating, ventilation and air c… - a moderate-severity action.
CPSC, Invensys Building Systems Announce Recall of Siebe Actuators in Building Fire/Smoke… was recalled by Invensys Building Systems, of Love Park, Ill. in October 2, 2002. Reason: A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spr…. Remedy: To be eligible for a free actuator replacement, the building owner must test the actuator…. Verify recall #03502 with the CPSC before acting.
The recall
Invensys Building Systems, of Love Park, Ill. issued this moderate-severity CPSC recall-A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spr….
Sourced from official CPSC enforcement records. Verify recall #03502 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
This CPSC action (record #03502) was formally reported on October 2, 2002. It is classified under Moderate severity, with a current status of Active. Invensys Building Systems, of Love Park, Ill. is listed as the recalling firm. Federal records list the affected scope as Up to 560,000.
The documented reason for this recall is: A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spread of smoke, fire and fumes. The recalled actuators can jam and prevent the dampers from closing. If dampers … Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: To be eligible for a free actuator replacement, the building owner must test the actuator and report the results to Invensys. Only actuators that fail testing will be replaced. - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Where this recall sits in its category - 3,056 household products recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Severity
Moderate
Affected scope
Up to 560,000
Related Recalls
6
6 from same agency
Actuators hold open fire and smoke dampers in a building's heating, ventilation and air conditioning (HVAC) system. A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spread of smoke, fire and fumes. These MA-200 and MA-200-1 series actuators were used in fire and smoke dampers that were manufactured by various companies from December 1993 through October 1999, which were installed by private contractors in commercial and residential buildings. The actuators have manufacture date codes of 9348 through 9947.
A spring mechanism integrated with the damper, is designed to close the damper during a fire to limit the spread of smoke, fire and fumes. The recalled actuators can jam and prevent the dampers from closing. If dampers fail to close during a fire, serious injury or death can be suffered by building occupants because smoke, fire and fumes can spread through a building's ventilation system.
To be eligible for a free actuator replacement, the building owner must test the actuator and report the results to Invensys. Only actuators that fail testing will be replaced.
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 03502 |
| Date reported | October 2, 2002 |
| Date initiated | October 2, 2002 |
| Recalling firm | Invensys Building Systems, of Love Park, Ill. |
| Affected scope | Up to 560,000 |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
To be eligible for a free actuator replacement, the building owner must test the actuator and report the results to Invensys. Onl…
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
Cooper Lighting, LLC, of Peachtree City, Georgia · 2026-07-02
· 2026-07-02
· 2026-07-02
· 2026-06-25
· 2026-06-25
Compare this recall with Cooper Lighting Recalls Metalux Optimized High Bay LED Ligh… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported October 2, 2002. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.