Severity
Moderate
ModerateActive
CPSC recall · Reported January 29, 2003
CPSC, Xerox International Partners Announce Retrofit of Network Laser Printers
Arcing may cause the fuser assembly to overheat, posing a fire hazard.
Compiled from official public sources by the editorial team.
Verify with CPSC →
Xerox International Partners, of Palo Alto, Calif. recalled These network laser printers were manufactured from January 1995 through September 1998. … - a moderate-severity action.
CPSC, Xerox International Partners Announce Retrofit of Network Laser Printers was recalled by Xerox International Partners, of Palo Alto, Calif. in January 29, 2003. Reason: Arcing may cause the fuser assembly to overheat, posing a fire hazard.. Remedy: Users should (1) switch off the printer power when unattended; (2) ensure that the "power…. Verify recall #03519 with the CPSC before acting.
The recall
Xerox International Partners, of Palo Alto, Calif. issued this moderate-severity CPSC recall-Arcing may cause the fuser assembly to overheat, posing a fire hazard..
- Moderate
- severity level
- January 29, 2003
- reported
Sourced from official CPSC enforcement records. Verify recall #03519 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
This CPSC action (record #03519) was formally reported on January 29, 2003. It is classified under Moderate severity, with a current status of Active. Xerox International Partners, of Palo Alto, Calif. is listed as the recalling firm. Federal records list the affected scope as About 17,000.
The documented reason for this recall is: Arcing may cause the fuser assembly to overheat, posing a fire hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Users should (1) switch off the printer power when unattended; (2) ensure that the "power save" mode is enabled; and (3) contact their commercial distributor for information on obtaining a free retro… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Household Products recalls over time
Where this recall sits in its category - 3,056 household products recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Affected scope
About 17,000
Related Recalls
6
6 from same agency
Product description
These network laser printers were manufactured from January 1995 through September 1998. Model numbers are on the top of the unit and on a label located on the rear panel. The retrofit is for the following model numbers: Xerox Engineering Systems - Model 8808 Hitachi Printing Solutions America - Models Typhoon 8 and Typhoon 16 GCC Technologies - Models Elite XL408, Elite XL608, Elite XL608LC, Elite XL808, Elite XL1208, Elite XL1208 PM, and Elite XL616
Reason for recall
Arcing may cause the fuser assembly to overheat, posing a fire hazard.
Remedy, what to do
Users should (1) switch off the printer power when unattended; (2) ensure that the "power save" mode is enabled; and (3) contact their commercial distributor for information on obtaining a free retrofit.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 03519 |
| Date reported | January 29, 2003 |
| Date initiated | January 29, 2003 |
| Recalling firm | Xerox International Partners, of Palo Alto, Calif. |
| Affected scope | About 17,000 |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Users should (1) switch off the printer power when unattended; (2) ensure that the "power save" mode is enabled; and (3) contact …
- Check the recall number (03519) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
These network laser printers were manufactured from January 1995 through September 1998. Model numbers are on the top of the unit and on a label located on the rear panel. The retrofit is for the following model numbers: Xerox Engineering Systems - Model 8808 Hitachi Printing Solutions America - Models Typhoon 8 and Typhoon 16 GCC Technologies - Models Elite XL408, Elite XL608, Elite XL608LC, Elite XL808, Elite XL1208, Elite XL1208 PM, and Elite XL616. Recalled by Xerox International Partners, of Palo Alto, Calif.. Units affected: About 17,000.
Why was this product recalled? ▼
Arcing may cause the fuser assembly to overheat, posing a fire hazard.
What should consumers do? ▼
Users should (1) switch off the printer power when unattended; (2) ensure that the "power save" mode is enabled; and (3) contact their commercial distributor for information on obtaining a free retrofit.
Which agency issued this recall? ▼
This recall was issued by the CPSC on January 29, 2003. Severity: Moderate. Recall number: 03519.
How do I check if my product is affected by a recall? ▼
Check the product description and recall number (03519) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product? ▼
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.
Nearby Recalls in This Category
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
CPSC Moderate
Cooper Lighting Recalls Metalux Optimized High Bay LED Light Fixtures Due to Fire Hazard
Cooper Lighting, LLC, of Peachtree City, Georgia · 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Roman Candles 8 Shot Fireworks Due to Risk of Serious Injury from Explosion and B…
· 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Unity 7 Shot 200 Gram Aerial Cake Fireworks Due to Risk of Serious Injury from Ex…
· 2026-07-02
CPSC Moderate
Kith Retail Recalls Children's Loungewear Sets Due to Risk of Serious Injury from Burn Hazard; Violate Mandatory Standa…
· 2026-06-25
CPSC Moderate
Southern Telecom Expands Recall of Lomi Waxing Kits Due to Risk of Serious Injury or Death from Fire and Burn Hazards; …
· 2026-06-25
Compare this recall with Cooper Lighting Recalls Metalux Optimized High Bay LED Ligh… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported January 29, 2003. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.