CPSC, Wagner Spray Tech Corporation Announce Recall of Drill Charger Base

Recall Insight

This CPSC action (record #04091) was formally reported on March 2, 2004. It is classified under Moderate severity, with a current status of Active. Wagner Spray Tech Corp., of Plymouth, Minn. is listed as the recalling firm. Federal records indicate 180,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: A defective battery can cause the charger base to overheat, causing the base to melt and possibly burn nearby objects. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Stop using the charger base and contact Wagner Spray Tech for information on receiving a replacement charger base. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 22 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.