PlainRecalls
No agency classActive

CPSC recall · Reported April 27, 2005

CPSC, Bell & Gossett Announce Recall of Dual Unit Valves

Burn injury from a hot water leak.

Recall #
05566
Affected scope
1,500
Verify with CPSC →
View my saved recalls

ITT-Bell & Gossett Division, of Morton Grove, Ill. recalled Dual Unit Valve, model numbers 8, 8 TU, F-8 and F-8TU, Bell & Gossett part numbers: 11019….

CPSC, Bell & Gossett Announce Recall of Dual Unit Valves was recalled by ITT-Bell & Gossett Division, of Morton Grove, Ill. in April 27, 2005. Reason: Burn injury from a hot water leak.. Remedy: Stop sales of affected valves and make arrangements for return to the factory through the…. Verify recall #05566 with the CPSC before acting.

The recall

ITT-Bell & Gossett Division, of Morton Grove, Ill. issued this CPSC recall-Burn injury from a hot water leak..

None
agency class
2K units
affected scope
April 27, 2005
reported

Sourced from official CPSC enforcement records. Verify recall #05566 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Household Products recalls over time

Where this recall sits in its category - 3,089 household products recalls on record

50100150200250 20052008201120142017202020232026 148

Product description

Dual Unit Valve, model numbers 8, 8 TU, F-8 and F-8TU, Bell & Gossett part numbers: 110199, 110200, 110201, and 110202 with a manufacturing date code of E30 (May 2003) through M40 (December 2004). This includes the following specific date codes -E30, F30, G30, H30, J30, K30, L30, M30, A40, B40, C40, D40, E40, F40, J40, K40, L40, and M40. This recall applies strictly to products that have not been installed. Units already installed are not affected, since the potential leak would appear at time of installation. The valves are used in residential heating systems, for filling hot water boilers and related piping systems after boiler installation or system servicing.

Reason for recall

Burn injury from a hot water leak.

Remedy, what to do

Stop sales of affected valves and make arrangements for return to the factory through the authorized B&G representative in your area. The local B&G representative can be identified via the "Rep Locator" selection tool on the following website: www.bellgossett.com All returned products will be replaced in a timely manner. All affected units in distribution have been recovered.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 05566
Date reported April 27, 2005
Date initiated April 27, 2005
Recalling firm ITT-Bell & Gossett Division, of Morton Grove, Ill.
Affected scope 1,500
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

1,500 units affected - limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units) -
Large-scale (100K – 1M units) -
Massive (≥1M units) -

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

What to do with this recall

Stop sales of affected valves and make arrangements for return to the factory through the authorized B&G representative in your a…

  • Check the recall number (05566) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
Dual Unit Valve, model numbers 8, 8 TU, F-8 and F-8TU, Bell & Gossett part numbers: 110199, 110200, 110201, and 110202 with a manufacturing date code of E30 (May 2003) through M40 (December 2004). This includes the following specific date codes -E30, F30, G30, H30, J30, K30, L30, M30, A40, B40, C40, D40, E40, F40, J40, K40, L40, and M40. This recall applies strictly to products that have not been installed. Units already installed are not affected, since the potential leak would appear at time of installation. The valves are used in residential heating systems, for filling hot water boilers and related piping systems after boiler installation or system servicing.. Recalled by ITT-Bell & Gossett Division, of Morton Grove, Ill.. Units affected: 1,500.
Why was this product recalled?
Burn injury from a hot water leak.
What should consumers do?
Stop sales of affected valves and make arrangements for return to the factory through the authorized B&G representative in your area. The local B&G representative can be identified via the "Rep Locator" selection tool on the following website: www.bellgossett.com All returned products will be replaced in a timely manner. All affected units in distribution have been recovered.
Which agency issued this recall?
This recall was issued by the CPSC on April 27, 2005. CPSC does not publish a hazard classification for this recall. Recall number: 05566.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with CCM Hockey U.S. Recalls FMHVR Hybrid Visors and ACCHVR Repl… → · All Household Products recalls

This recall: CPSC, reported April 27, 2005. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026