SRAM Corp. Recalls Bicycle Brake Caliper Sets Due to Crash Hazard

Recall Insight

This CPSC action (record #07153) was formally reported on April 10, 2007. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. The number of affected units is not disclosed in the agency filing, which is common for drug and food recalls where lot-level tracking supersedes unit counts.

The documented reason for this recall is: The brake caliper sets could break and detach from the bicycle's fork or frame. This could cause the rider to lose control and crash. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using bicycles equipped with these brake caliper sets immediately and contact their bicycle retailer for a free replacement. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 1 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 19 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.