BCI Recalls Swing Sets Due to Fall Hazard

Recall Insight

This CPSC action (record #07579) was formally reported on September 25, 2007. It is classified under Moderate severity, with a current status of Active. BCI Burke Company LLC, of Fond du Lac, Wisc. is listed as the recalling firm. Federal records indicate About 670 units are affected.

The documented reason for this recall is: The connection on the top beam of the swing set can break, causing the swing beam to collapse, posing a fall hazard to the user. A user or bystander also can be injured by the falling top rail. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the product immediately and remove the existing swings from the top beam immediately. Consumers can re-install the swings once the repair kit is received and installed wit… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 19 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.