PlainRecalls

Reynolds Recalls Bicycle Forks Due to Fall Hazard

Reported: October 23, 2007 Initiated: October 23, 2007 #08040 About 330 units

MacLean Quality Composites, d.b.a. Reynolds, of West Jordan, Utah issued this CPSC recall on October 23, 2007. Classified as Moderate severity. Approximately About 330 units are affected. The recall was issued because: The fork tips could separate from the fork legs, causing the wheel to come loose from the fork while riding. This could…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #08040) was formally reported on October 23, 2007. It is classified under Moderate severity, with a current status of Active. MacLean Quality Composites, d.b.a. Reynolds, of West Jordan, Utah is listed as the recalling firm. Federal records indicate About 330 units are affected.

The documented reason for this recall is: The fork tips could separate from the fork legs, causing the wheel to come loose from the fork while riding. This could pose a serious fall hazard to riders. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the bicycles equipped with the recalled forks immediately and contact Reynolds for a free replacement fork. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 19 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 330

Related Recalls

6

6 from same agency

Product Description

This recall involves the Reynolds UL bicycle fork models with 43 mm and 50 mm rakes and with serial numbers 09100 through 10403. The serial number decal is located on the steer tube. To see the serial number, the fork must be removed from the frame. Some recalled forks are black, have "Reynolds" printed on them, and have a gray and white stripe painted on the legs of the fork. Other recalled forks were painted with a different paint scheme and do not have "Reynolds" printed on them. To determine if a fork is included in this recall, consumers should contact the company.

Reason for Recall

The fork tips could separate from the fork legs, causing the wheel to come loose from the fork while riding. This could pose a serious fall hazard to riders.

Remedy

Consumers should stop using the bicycles equipped with the recalled forks immediately and contact Reynolds for a free replacement fork.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 08040
Date reported October 23, 2007
Date initiated October 23, 2007
Recalling firm MacLean Quality Composites, d.b.a. Reynolds, of West Jordan, Utah
Units affected About 330
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 330 units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves the Reynolds UL bicycle fork models with 43 mm and 50 mm rakes and with serial numbers 09100 through 10403. The serial number decal is located on the steer tube. To see the serial number, the fork must be removed from the frame. Some recalled forks are black, have "Reynolds" printed on them, and have a gray and white stripe painted on the legs of the fork. Other recalled forks were painted with a different paint scheme and do not have "Reynolds" printed on them. To determine if a fork is included in this recall, consumers should contact the company.. Recalled by MacLean Quality Composites, d.b.a. Reynolds, of West Jordan, Utah. Units affected: About 330.
Why was this product recalled?
The fork tips could separate from the fork legs, causing the wheel to come loose from the fork while riding. This could pose a serious fall hazard to riders.
What should consumers do?
Consumers should stop using the bicycles equipped with the recalled forks immediately and contact Reynolds for a free replacement fork.
Which agency issued this recall?
This recall was issued by the CPSC on October 23, 2007. Severity: Moderate. Recall number: 08040.
How do I check if my product is affected by a recall?
Check the product description and recall number (08040) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Aisstxoer Adult Bicycle Helmets Recalled Due to Risk of Ser… →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).