PlainRecalls

Timberland Recalls Steel Toe Boots Due to Foot Injury Hazard

Reported: October 2, 2007 Initiated: October 2, 2007 #08500 About 193,000 pairs units

CPSC recall on October 2, 2007. Classified as Moderate severity. Approximately About 193,000 pairs units are affected. The recall was issued because: The boots could fail to provide the intended protection against compression and impact, posing the risk of a foot injur…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #08500) was formally reported on October 2, 2007. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 193,000 pairs units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: The boots could fail to provide the intended protection against compression and impact, posing the risk of a foot injury to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop wearing the recalled boots immediately and contact The Timberland Company to receive a free replacement pair of boots. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 19 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 193,000 pairs

Related Recalls

6

6 from same agency

Product Description

This recall involves the Timberland PRO Direct Attach Steel Toe Boots with model numbers 26002 (wheat nubuck leather), 65016 (wheat nubuck leather), 26038 (black full-grain leather), and 38021 (brown oiled full-grain leather). The model number is printed on a green loop tag on the inside of the boot, just below the size. The boots have a four digit date code ending in 35 and beginning with the numbers 25 through 45 (e.g. 2535, 2635.4535) which can also be found on the loop tag below the model number. Direct Attach Steel Toe boots made in China are not subject to this recall.

Reason for Recall

The boots could fail to provide the intended protection against compression and impact, posing the risk of a foot injury to consumers.

Remedy

Consumers should stop wearing the recalled boots immediately and contact The Timberland Company to receive a free replacement pair of boots.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 08500
Date reported October 2, 2007
Date initiated October 2, 2007
Recalling firm Not disclosed
Units affected About 193,000 pairs
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 193,000 pairs units affected — multi-state distribution scale.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units) ✓ This recall
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves the Timberland PRO Direct Attach Steel Toe Boots with model numbers 26002 (wheat nubuck leather), 65016 (wheat nubuck leather), 26038 (black full-grain leather), and 38021 (brown oiled full-grain leather). The model number is printed on a green loop tag on the inside of the boot, just below the size. The boots have a four digit date code ending in 35 and beginning with the numbers 25 through 45 (e.g. 2535, 2635.4535) which can also be found on the loop tag below the model number. Direct Attach Steel Toe boots made in China are not subject to this recall.. Units affected: About 193,000 pairs.
Why was this product recalled?
The boots could fail to provide the intended protection against compression and impact, posing the risk of a foot injury to consumers.
What should consumers do?
Consumers should stop wearing the recalled boots immediately and contact The Timberland Company to receive a free replacement pair of boots.
Which agency issued this recall?
This recall was issued by the CPSC on October 2, 2007. Severity: Moderate. Recall number: 08500.
How do I check if my product is affected by a recall?
Check the product description and recall number (08500) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Electrolux Group Recalls Frigidaire Gas Ranges Due to Burn … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).