Severity
Moderate
ModerateActive
CPSC recall · Reported May 15, 2009
Digital Clamp Meters Recalled by Fluke Due to Shock Hazard
The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the electrical power is off, posing a shock, electrocution, or thermal burn…
Compiled from official public sources by the editorial team.
Verify with CPSC →
Fluke Corp., of Everett, Wash. recalled This recall involves Fluke Digital Clamp Meters with model and serial numbers listed belo… - a moderate-severity action.
Digital Clamp Meters Recalled by Fluke Due to Shock Hazard was recalled by Fluke Corp., of Everett, Wash. in May 15, 2009. Reason: The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the e…. Remedy: Consumers should stop using these recalled Digital Clamp Meters immediately and contact F…. Verify recall #09222 with the CPSC before acting.
The recall
Fluke Corp., of Everett, Wash. issued this moderate-severity CPSC recall-The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the e….
- Moderate
- severity level
- May 15, 2009
- reported
Sourced from official CPSC enforcement records. Verify recall #09222 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
This CPSC action (record #09222) was formally reported on May 15, 2009. It is classified under Moderate severity, with a current status of Active. Fluke Corp., of Everett, Wash. is listed as the recalling firm. Federal records list the affected scope as About 52,000.
The documented reason for this recall is: The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the electrical power is off, posing a shock, electrocution, or thermal burn hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using these recalled Digital Clamp Meters immediately and contact Fluke for a free replacement clamp meter. - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Household Products recalls over time
Where this recall sits in its category - 3,056 household products recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Affected scope
About 52,000
Related Recalls
6
6 from same agency
Product description
This recall involves Fluke Digital Clamp Meters with model and serial numbers listed below. The model number may be followed by an "A." Model No. Starting With Serial No. Starting with Serial No. Ending In 333 97010000 98880240 334 97010000 98870101 335 97010000 98860104 336 96220000 98900400 337 96070000 98890607 Serial numbers that begin with "S" or are followed by "R" are not included in the recall. "Fluke" and the model number are printed on the front of the unit and the serial number on the back. The instrument body is yellow, red, and black. The clamp meters measure 0 to 600 volts alternating current (VAC), 0 to 600 volts direct current (VDC) and 0 to 400, 600 or 1000 amps alternating current.
Reason for recall
The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the electrical power is off, posing a shock, electrocution, or thermal burn hazard.
Remedy, what to do
Consumers should stop using these recalled Digital Clamp Meters immediately and contact Fluke for a free replacement clamp meter.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 09222 |
| Date reported | May 15, 2009 |
| Date initiated | May 15, 2009 |
| Recalling firm | Fluke Corp., of Everett, Wash. |
| Affected scope | About 52,000 |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should stop using these recalled Digital Clamp Meters immediately and contact Fluke for a free replacement clamp meter.
- Check the recall number (09222) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
This recall involves Fluke Digital Clamp Meters with model and serial numbers listed below. The model number may be followed by an "A." Model No. Starting With Serial No. Starting with Serial No. Ending In 333 97010000 98880240 334 97010000 98870101 335 97010000 98860104 336 96220000 98900400 337 96070000 98890607 Serial numbers that begin with "S" or are followed by "R" are not included in the recall. "Fluke" and the model number are printed on the front of the unit and the serial number on the back. The instrument body is yellow, red, and black. The clamp meters measure 0 to 600 volts alternating current (VAC), 0 to 600 volts direct current (VDC) and 0 to 400, 600 or 1000 amps alternating current.. Recalled by Fluke Corp., of Everett, Wash.. Units affected: About 52,000.
Why was this product recalled? ▼
The meters can fail to give an appropriate voltage reading, resulting in the operator falsely believing the electrical power is off, posing a shock, electrocution, or thermal burn hazard.
What should consumers do? ▼
Consumers should stop using these recalled Digital Clamp Meters immediately and contact Fluke for a free replacement clamp meter.
Which agency issued this recall? ▼
This recall was issued by the CPSC on May 15, 2009. Severity: Moderate. Recall number: 09222.
How do I check if my product is affected by a recall? ▼
Check the product description and recall number (09222) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product? ▼
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.
Nearby Recalls in This Category
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
CPSC Moderate
Cooper Lighting Recalls Metalux Optimized High Bay LED Light Fixtures Due to Fire Hazard
Cooper Lighting, LLC, of Peachtree City, Georgia · 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Roman Candles 8 Shot Fireworks Due to Risk of Serious Injury from Explosion and B…
· 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Unity 7 Shot 200 Gram Aerial Cake Fireworks Due to Risk of Serious Injury from Ex…
· 2026-07-02
CPSC Moderate
Kith Retail Recalls Children's Loungewear Sets Due to Risk of Serious Injury from Burn Hazard; Violate Mandatory Standa…
· 2026-06-25
CPSC Moderate
Southern Telecom Expands Recall of Lomi Waxing Kits Due to Risk of Serious Injury or Death from Fire and Burn Hazards; …
· 2026-06-25
Compare this recall with Cooper Lighting Recalls Metalux Optimized High Bay LED Ligh… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported May 15, 2009. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.