Bicycle Chains and Chain Connector Links Recalled by SRAM Due to Fall Hazard

Recall Insight

This CPSC action (record #09342) was formally reported on September 8, 2009. It is classified under Moderate severity, with a current status of Active. SRAM LLC, of Chicago, Ill. is listed as the recalling firm. Federal records indicate About 24,000 units are affected.

The documented reason for this recall is: The recalled PowerLock connector links, used on bicycle chains, are brittle and can crack, allowing the chain to separate from the bicycle and posing a fall hazard to the rider. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled PowerLock connectors, chains and bicycles with these connectors and contact their SRAM retailer for a free replacement PowerLock connector link. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 17 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.