Teknion Recalls to Repair Office Chairs Due to Fall Hazard

Recall Insight

This CPSC action (record #09716) was formally reported on December 23, 2008. It is classified under Moderate severity, with a current status of Active. Okamura Corp., of Japan is listed as the recalling firm. Federal records indicate About 60,000 units are affected.

The documented reason for this recall is: The bolts holding the seat to the frame can loosen and separate, posing a fall hazard to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should inspect the chair by checking the four bolts that attach the seat bottom to the chair frame. If any of the four bolts is loose or missing, consumers should stop using the chair immed… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 18 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.