PlainRecalls

Risk of Strangulation Prompts Recall to Repair Roman Shades; Sold Exclusively by Restoration Hardware Baby & Child

Reported: December 17, 2009 Initiated: December 17, 2009 #10712 About 4,600 units units

CPSC recall on December 17, 2009. Classified as Moderate severity. Approximately About 4,600 units units are affected. The recall was issued because: Strangulation can occur when a child places his/her neck between the exposed inner cord and the fabric on the backside …. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #10712) was formally reported on December 17, 2009. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 4,600 units units are affected.

The documented reason for this recall is: Strangulation can occur when a child places his/her neck between the exposed inner cord and the fabric on the backside of the blind or when a child pulls the cord out and wraps it around his/her neck. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using these Roman shades and contact Restoration Hardware Baby & Child to receive a free repair kit. All known purchasers have been contacted by the firm. The free r… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 17 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 4,600 units

Related Recalls

6

6 from same agency

Product Description

This recall involves all Roman shades with black-out lining sold by Restoration Hardware Baby & Child. These shades measure 23, 32, 36 and 48 inches wide by 64 inches long. There is a label sewn on the left lower corner on the back of the shade that states "baby & child Restoration Hardware" and "Made in China." For additional description information of the recalled products go to www.rhbabyandchild.com

Reason for Recall

Strangulation can occur when a child places his/her neck between the exposed inner cord and the fabric on the backside of the blind or when a child pulls the cord out and wraps it around his/her neck.

Remedy

Consumers should immediately stop using these Roman shades and contact Restoration Hardware Baby & Child to receive a free repair kit. All known purchasers have been contacted by the firm. The free repair kit will be available within six weeks.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 10712
Date reported December 17, 2009
Date initiated December 17, 2009
Recalling firm Not disclosed
Units affected About 4,600 units
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 4,600 units units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves all Roman shades with black-out lining sold by Restoration Hardware Baby & Child. These shades measure 23, 32, 36 and 48 inches wide by 64 inches long. There is a label sewn on the left lower corner on the back of the shade that states "baby & child Restoration Hardware" and "Made in China." For additional description information of the recalled products go to www.rhbabyandchild.com. Units affected: About 4,600 units.
Why was this product recalled?
Strangulation can occur when a child places his/her neck between the exposed inner cord and the fabric on the backside of the blind or when a child pulls the cord out and wraps it around his/her neck.
What should consumers do?
Consumers should immediately stop using these Roman shades and contact Restoration Hardware Baby & Child to receive a free repair kit. All known purchasers have been contacted by the firm. The free repair kit will be available within six weeks.
Which agency issued this recall?
This recall was issued by the CPSC on December 17, 2009. Severity: Moderate. Recall number: 10712.
How do I check if my product is affected by a recall?
Check the product description and recall number (10712) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Infant Walkers Recalled Due to Risk of Serious Injury or De… →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).