PlainRecalls
ModerateActive

CPSC recall · Reported July 6, 2010

Marley Engineered Products Recalls Baseboard Heaters Sold at Grainger Due to Fire Hazard

The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heater built for a maximum of 120 volts. If the heater is connected to a 2…

Recall #
10745
Affected scope
About 30
Compiled from official public sources by the editorial team.
Verify with CPSC →
View my saved recalls

Marley Engineered Products LLC, of Bennettsville, S.c. recalled This recall involves Dayton 240/208 volt model 3UG82D electric baseboard heaters. The whi… - a moderate-severity action.

Marley Engineered Products Recalls Baseboard Heaters Sold at Grainger Due to Fire Hazard was recalled by Marley Engineered Products LLC, of Bennettsville, S.c. in July 6, 2010. Reason: The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heat…. Remedy: Consumers should immediately stop using the heaters and inspect the product's nameplate t…. Verify recall #10745 with the CPSC before acting.

The recall

Marley Engineered Products LLC, of Bennettsville, S.c. issued this moderate-severity CPSC recall-The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heat….

Moderate
severity level
July 6, 2010
reported

Sourced from official CPSC enforcement records. Verify recall #10745 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This CPSC action (record #10745) was formally reported on July 6, 2010. It is classified under Moderate severity, with a current status of Active. Marley Engineered Products LLC, of Bennettsville, S.c. is listed as the recalling firm. Federal records list the affected scope as About 30.

The documented reason for this recall is: The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heater built for a maximum of 120 volts. If the heater is connected to a 240 or 208 volt electrical circuit as dir… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the heaters and inspect the product's nameplate to determine whether it is involved in the recall. Consumers with affected heaters should disconnect the produc… - consumers holding this product should act on that instruction rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Appliances recalls over time

Where this recall sits in its category - 419 appliances recalls on record

0102030405060 20052008201120142017202020232026 9
Severity2487872426High severity (most serious)Moderate severityLow severity
Where this recall sits in the database

Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.

Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.

Severity

Moderate

Affected scope

About 30

Related Recalls

6

6 from same agency

Product description

This recall involves Dayton 240/208 volt model 3UG82D electric baseboard heaters. The white, rectangular heaters are 30 inches long by 6 3/4 inches high by 2 7/8 inches deep. A nameplate on the bottom right side of the base has "Dayton Electric Mfg. Co.," model 3UG82D and date code 1209. Only heaters purchased after December 21, 2009 with a date code of "1209" are included in this recall. The recalled heaters have yellow and white wires inside the panel where the heater connects to the power source. Heaters with red and black wire are not included in this recall.

Reason for recall

The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heater built for a maximum of 120 volts. If the heater is connected to a 240 or 208 volt electrical circuit as directed, the unit could catch fire.

Remedy, what to do

Consumers should immediately stop using the heaters and inspect the product's nameplate to determine whether it is involved in the recall. Consumers with affected heaters should disconnect the product at the circuit breaker or fuse. A qualified electrician should inspect the color of the wires inside the heater's electrical access panel to determine if the wires are yellow and white. Consumers should return the affected heaters to Marley for a free replacement. Marley will pay reasonable labor charges required to inspect and exchange units. Marley is directly notifying known consumers.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 10745
Date reported July 6, 2010
Date initiated July 6, 2010
Recalling firm Marley Engineered Products LLC, of Bennettsville, S.c.
Affected scope About 30
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should immediately stop using the heaters and inspect the product's nameplate to determine whether it is involved in th…

  • Check the recall number (10745) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
This recall involves Dayton 240/208 volt model 3UG82D electric baseboard heaters. The white, rectangular heaters are 30 inches long by 6 3/4 inches high by 2 7/8 inches deep. A nameplate on the bottom right side of the base has "Dayton Electric Mfg. Co.," model 3UG82D and date code 1209. Only heaters purchased after December 21, 2009 with a date code of "1209" are included in this recall. The recalled heaters have yellow and white wires inside the panel where the heater connects to the power source. Heaters with red and black wire are not included in this recall.. Recalled by Marley Engineered Products LLC, of Bennettsville, S.c.. Units affected: About 30.
Why was this product recalled?
The baseboard heaters are labeled for 240 or 208 volt use. However, some of the heaters have an internal heater built for a maximum of 120 volts. If the heater is connected to a 240 or 208 volt electrical circuit as directed, the unit could catch fire.
What should consumers do?
Consumers should immediately stop using the heaters and inspect the product's nameplate to determine whether it is involved in the recall. Consumers with affected heaters should disconnect the product at the circuit breaker or fuse. A qualified electrician should inspect the color of the wires inside the heater's electrical access panel to determine if the wires are yellow and white. Consumers should return the affected heaters to Marley for a free replacement. Marley will pay reasonable labor charges required to inspect and exchange units. Marley is directly notifying known consumers.
Which agency issued this recall?
This recall was issued by the CPSC on July 6, 2010. Severity: Moderate. Recall number: 10745.
How do I check if my product is affected by a recall?
Check the product description and recall number (10745) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nearby Recalls in This Category

Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with HSN Recalls Kitchen HQ Thermal Insulated Bowls Due to Fire … →

Browse all Appliances recalls →

Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported July 6, 2010. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.