PlainRecalls

HONDA 2006-2007: ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL

Reported: January 4, 2010 Initiated: January 4, 2010 #10V001000

HONDA issued this NHTSA recall on January 4, 2010. Classified as Critical severity. The recall was issued because: HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE …. This recall notice is sourced from official NHTSA enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This NHTSA action (record #10V001000) was formally reported on January 4, 2010. It is classified under Critical severity, with a current status of Active. HONDA is listed as the recalling firm. The number of affected units is not disclosed in the agency filing, which is common for drug and food recalls where lot-level tracking supersedes unit counts.

The documented reason for this recall is: HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE 7, 2006. A WIRING HARNESS CONNECTOR FOR THE HEATING, VENTILATION AND AIR CONDITIONING (HVAC) BLOWER … The specific hazard cited in the filing is: SHOULD THE WIRING INSULATION MELT AND THE EXPOSED WIRES MAKE CONTACT WITH EACH OTHER (SHORT CIRCUIT), A FIRE MAY OCCUR.. Distribution data in the federal record shows the product reached: United States. Distribution scope directly affects the consumer exposure window and determines whether a recall remains regional or escalates into a nationwide advisory. The remedy documented by the agency is: DEALERS WILL INSPECT AND IF THE WIRING CONNECTOR IS DAMAGED IT WILL BE REPLACED AND ALL VEHICLES WILL HAVE THE PROTECTIVE COVER INSTALLED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 15, 2010. … — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 1 were also issued by NHTSA. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 16 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Critical

Units Affected

Unknown

Related Recalls

6

1 from same agency

Product Description

HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE 7, 2006. A WIRING HARNESS CONNECTOR FOR THE HEATING, VENTILATION AND AIR CONDITIONING (HVAC) BLOWER MOTOR LOCATED UNDER THE PASSENGER'S SIDE OF THE INSTRUMENT PANEL MAY BE ACCESSIBLE TO KICKING BY THE FRONT SEAT PASSENGER'S FEET. IF THIS OCCURS, THE CONNECTOR TERMINAL MAY OVERHEAT, AND THIS MAY CAUSE THE WIRE INSULATION TO MELT OR THE WIRING CONNECTOR TO MELT.

Reason for Recall

HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE 7, 2006. A WIRING HARNESS CONNECTOR FOR THE HEATING, VENTILATION AND AIR CONDITIONING (HVAC) BLOWER MOTOR LOCATED UNDER THE PASSENGER'S SIDE OF THE INSTRUMENT PANEL MAY BE ACCESSIBLE TO KICKING BY THE FRONT SEAT PASSENGER'S FEET. IF THIS OCCURS, THE CONNECTOR TERMINAL MAY OVERHEAT, AND THIS MAY CAUSE THE WIRE INSULATION TO MELT OR THE WIRING CONNECTOR TO MELT.

Hazard

SHOULD THE WIRING INSULATION MELT AND THE EXPOSED WIRES MAKE CONTACT WITH EACH OTHER (SHORT CIRCUIT), A FIRE MAY OCCUR.

Remedy

DEALERS WILL INSPECT AND IF THE WIRING CONNECTOR IS DAMAGED IT WILL BE REPLACED AND ALL VEHICLES WILL HAVE THE PROTECTIVE COVER INSTALLED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 15, 2010. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.

Details

Recalling Firm
HONDA
Distribution
United States

Recall Profile

Structured summary of the NHTSA recall record
Attribute Value
Agency National Highway Traffic Safety Administration
Severity class Critical
Status Active
Recall number 10V001000
Date reported January 4, 2010
Date initiated January 4, 2010
Recalling firm HONDA
Units affected Not disclosed
Distribution United States

Profile values are sourced directly from the official NHTSA enforcement record. Source: National Highway Traffic Safety Administration.

Frequently Asked Questions

What product was recalled?
HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE 7, 2006. A WIRING HARNESS CONNECTOR FOR THE HEATING, VENTILATION AND AIR CONDITIONING (HVAC) BLOWER MOTOR LOCATED UNDER THE PASSENGER'S SIDE OF THE INSTRUMENT PANEL MAY BE ACCESSIBLE TO KICKING BY THE FRONT SEAT PASSENGER'S FEET. IF THIS OCCURS, THE CONNECTOR TERMINAL MAY OVERHEAT, AND THIS MAY CAUSE THE WIRE INSULATION TO MELT OR THE WIRING CONNECTOR TO MELT.. Recalled by HONDA.
Why was this product recalled?
HONDA IS RECALLING CERTAIN MODEL YEAR 2006 AND 2007 RIDGELINE VEHICLES MANUFACTURED BETWEEN JANUARY 17, 2005, AND JUNE 7, 2006. A WIRING HARNESS CONNECTOR FOR THE HEATING, VENTILATION AND AIR CONDITIONING (HVAC) BLOWER MOTOR LOCATED UNDER THE PASSENGER'S SIDE OF THE INSTRUMENT PANEL MAY BE ACCESSIBLE TO KICKING BY THE FRONT SEAT PASSENGER'S FEET. IF THIS OCCURS, THE CONNECTOR TERMINAL MAY OVERHEAT, AND THIS MAY CAUSE THE WIRE INSULATION TO MELT OR THE WIRING CONNECTOR TO MELT.
What should consumers do?
DEALERS WILL INSPECT AND IF THE WIRING CONNECTOR IS DAMAGED IT WILL BE REPLACED AND ALL VEHICLES WILL HAVE THE PROTECTIVE COVER INSTALLED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 15, 2010. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.
Which agency issued this recall?
This recall was issued by the NHTSA on January 4, 2010. Severity: Critical. Recall number: 10V001000.
Where was the recalled product distributed?
Distribution: United States.
How do I check if my product is affected by a recall?
Check the product description and recall number (10V001000) against your product. Visit the official NHTSA website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as critical severity, meaning the product carries a reasonable probability of serious adverse health consequences or death. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Amazon Recalls Amazon Basics Camping Folding Pocket Knives … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).