NHTSA recall · Reported December 15, 2010
HONDA 2007-2008: EXTERIOR LIGHTING:HEADLIGHTS:HIGH/LOW BEAM DIMMER SWITCH
HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTI…
Honda recalled HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTAL….
HONDA 2007-2008: EXTERIOR LIGHTING:HEADLIGHTS:HIGH/LOW BEAM DIMMER SWITCH was recalled by Honda in December 15, 2010. Reason: HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING…. Remedy: DEALERS WILL INSPECT THE LOW BEAM TERMINAL AND PERFORM NECESSARY REPAIRS FREE OF CHARGE. …. Verify recall #10V624000 with the NHTSA before acting.
The recall
Honda issued this NHTSA recall-HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING….
- None
- agency class
- December 15, 2010
- reported
Sourced from official NHTSA enforcement records. Verify recall #10V624000 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
The number of affected units is not disclosed in the agency filing, which is common for drug and food recalls where lot-level tracking supersedes unit counts. Distribution scope (see Distribution below) directly affects the consumer exposure window and determines whether a recall remains regional or escalates into a nationwide advisory. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 3 from NHTSA - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Vehicles recalls over time
Where this recall sits in its category - 7,783 vehicles recalls on record
Product description
HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.
Reason for recall
HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.
Hazard
THE LOW BEAM HEADLIGHTS CAN BECOME INOPERATIVE DECREASING THE DRIVER'S VISIBILITY AS WELL AS THE VEHICLE'S VISIBILITY TO OTHER DRIVERS, INCREASING THE RISK OF A CRASH.
Remedy, what to do
DEALERS WILL INSPECT THE LOW BEAM TERMINAL AND PERFORM NECESSARY REPAIRS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 24, 2011. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | National Highway Traffic Safety Administration |
| Severity class | Not classified by agency |
| Status | Active |
| Recall number | 10V624000 |
| Date reported | December 15, 2010 |
| Date initiated | December 15, 2010 |
| Recalling firm | Honda |
| Affected scope | Not disclosed |
| Distribution | United States |
| Official source | NHTSA notice → |
Profile values are sourced directly from the official NHTSA enforcement record. Source: National Highway Traffic Safety Administration.
What to do with this recall
DEALERS WILL INSPECT THE LOW BEAM TERMINAL AND PERFORM NECESSARY REPAIRS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 24, …
- Check the recall number (10V624000) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official NHTSA notice before acting. NHTSA notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official NHTSA record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
Why was this product recalled? ▼
What should consumers do? ▼
Which agency issued this recall? ▼
Where was the recalled product distributed? ▼
How do I report an injury from a recalled product? ▼
Nationwide recalls with similar severity or category timing
Vehicle and equipment notices outside this manufacturer and filing state, matched by archive severity grade and report timing.
Similar severity · nearest report date
Same archive severity grade, closest by report date among other firms and states.
Similar Vehicles · nearest report date
Same product category, closest by report date among other firms and states (deduped against the severity set).
Compare this recall with KTM North America Recalls Off-Road Motorcycles Due to Risk … → · All Vehicles recalls
Methodology · Corrections · Archive as of August 2026