Severity
Moderate
CPSC recall · Reported November 9, 2010
The frame mounting bolts and wheel axle bolts can be loose on new skates. Loose wheels or frames on the skates can cause the rider to fall, posing a risk of injury.
The CPSC recalled This recall involves the following models of inline skates purchased since September 2009… - a moderate-severity action.
Rollerblade USA Recalls to Repair Inline Skates Due to Risk of Injury was recalled and listed by the CPSC in November 9, 2010. Reason: The frame mounting bolts and wheel axle bolts can be loose on new skates. Loose wheels or frames on the skate…. Remedy: Consumers should immediately inspect all wheel-axle and frame-mounting bolts to ensure th…. Verify recall #11033 with the CPSC before acting.
The recall
issued this moderate-severity CPSC recall-The frame mounting bolts and wheel axle bolts can be loose on new skates. Loose wheels or frames on the skate….
Sourced from official CPSC enforcement records. Verify recall #11033 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
This CPSC action (record #11033) was formally reported on November 9, 2010. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records list the affected scope as About 29,000 pairs.
The documented reason for this recall is: The frame mounting bolts and wheel axle bolts can be loose on new skates. Loose wheels or frames on the skates can cause the rider to fall, posing a risk of injury. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately inspect all wheel-axle and frame-mounting bolts to ensure that they are properly tightened. Rollerblade USA recommends regular inspection and tightening of bolts. After w… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Where this recall sits in its category - 3,056 household products recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Severity
Moderate
Affected scope
About 29,000 pairs
Related Recalls
6
6 from same agency
This recall involves the following models of inline skates purchased since September 2009. - Spark Pro, Men's (SKU# 00792200816), Black - Spark Pro, Women's (SKU# 007923007E2), Anthracite (Grey) - Spark 80, Men's (SKU# 00702800956), Black - Spark 80, Women's (SKU# 007029009A6), Anthracite (Grey) - Spitfire, Boy's (SKU# 00705500741), Black - Spitfire, Girl's (SKU# 007056007Y8), Silver - Spitfire S, Boy's (SKU# 00705700956), Black - Spitfire S, Girl's (SKU# 007058009A7), Anthracite (Grey) - Spitfire LX, (SKU# 00705000955), Silver
The frame mounting bolts and wheel axle bolts can be loose on new skates. Loose wheels or frames on the skates can cause the rider to fall, posing a risk of injury.
Consumers should immediately inspect all wheel-axle and frame-mounting bolts to ensure that they are properly tightened. Rollerblade USA recommends regular inspection and tightening of bolts. After wheel-axle and frame mounting bolts are inspected and tightened if needed, products are acceptable for sale and use. Video instructions on bolt tightening and maintenance are available at www.rollerblade.com
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 11033 |
| Date reported | November 9, 2010 |
| Date initiated | November 9, 2010 |
| Recalling firm | Not disclosed |
| Affected scope | About 29,000 pairs |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should immediately inspect all wheel-axle and frame-mounting bolts to ensure that they are properly tightened. Rollerbl…
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
Cooper Lighting, LLC, of Peachtree City, Georgia · 2026-07-02
· 2026-07-02
· 2026-07-02
· 2026-06-25
· 2026-06-25
Compare this recall with Cooper Lighting Recalls Metalux Optimized High Bay LED Ligh… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported November 9, 2010. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.