Hoover Recalls WindTunnel Canister Vacuums Due to Fire and Shock Hazards

Recall Insight

This CPSC action (record #11124) was formally reported on February 9, 2011. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 142,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: The power cord between the power nozzle and the wand connector can short-circuit posing fire and shock hazards to consumers. This condition can occur even if the vacuum has been turned off but left plugged in. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled vacuum cleaners and contact Hoover for a free repair. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 15 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.