Honeywell Recalls Electric Baseboard and Fan Heater Thermostats Due to Burn Hazard

Recall Insight

This CPSC action (record #11289) was formally reported on July 28, 2011. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 77,000 units are affected.

The documented reason for this recall is: The thermostats can overheat, causing them to melt and smoke. This poses a burn hazard to the consumer. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled thermostats by setting the thermostats to 45 degrees or turning them off. Only models with a "B" in the model number have an off switch. Consumers… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 3 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 15 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.