Severity
Moderate
ModerateActive
CPSC recall · Reported April 19, 2012
Irwin Recalls 10-Inch Circular Saw Blade 3-Pack Due to Laceration Hazard Posed by Defective Packaging
The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard.
Irwin Industrial Tool Company, Huntersville, N.c. recalled This recall involves Irwin Classic Series 10-inch Circular Saw Blade Limited Promotion 3-… - a moderate-severity action.
Irwin Recalls 10-Inch Circular Saw Blade 3-Pack Due to Laceration Hazard Posed by Defecti… was recalled by Irwin Industrial Tool Company, Huntersville, N.c. in April 19, 2012. Reason: The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard.. Remedy: Consumers should immediately contact the firm to receive a free storage container for the…. Verify recall #12154 with the CPSC before acting.
The recall
Irwin Industrial Tool Company, Huntersville, N.c. issued this moderate-severity CPSC recall-The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard..
- Moderate
- severity level
- April 19, 2012
- reported
Sourced from official CPSC enforcement records. Verify recall #12154 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
This CPSC action (record #12154) was formally reported on April 19, 2012. It is classified under Moderate severity, with a current status of Active. Irwin Industrial Tool Company, Huntersville, N.c. is listed as the recalling firm. Federal records list the affected scope as About 55,260.
The documented reason for this recall is: The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately contact the firm to receive a free storage container for the saw blades. Consumers should not disturb any saw blades that remain in the packaging but should store the saw… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Household Products recalls over time
Where this recall sits in its category - 3,056 household products recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Affected scope
About 55,260
Related Recalls
6
6 from same agency
Product description
This recall involves Irwin Classic Series 10-inch Circular Saw Blade Limited Promotion 3-Packs. The blister packs contain one 10-inch trim and finish saw blade with 60 teeth (60T) and two 10-inch general purpose saw blades with 40 teeth (40T). The blades are stacked offset in the packs. The packaging is blue, orange and yellow and has the words "Irwin" and "Classic Series" on the front top left corner and "3 Circular Saw Blades" on the front lower left corner. Model number "ICSLD3PK" is located on the front top right corner.
Reason for recall
The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard.
Remedy, what to do
Consumers should immediately contact the firm to receive a free storage container for the saw blades. Consumers should not disturb any saw blades that remain in the packaging but should store the saw blades in the packaging in a safe and secure location until the container arrives, then immediately transfer the saw blades to the container and discard the original packaging.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 12154 |
| Date reported | April 19, 2012 |
| Date initiated | April 19, 2012 |
| Recalling firm | Irwin Industrial Tool Company, Huntersville, N.c. |
| Affected scope | About 55,260 |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should immediately contact the firm to receive a free storage container for the saw blades. Consumers should not distur…
- Check the recall number (12154) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
This recall involves Irwin Classic Series 10-inch Circular Saw Blade Limited Promotion 3-Packs. The blister packs contain one 10-inch trim and finish saw blade with 60 teeth (60T) and two 10-inch general purpose saw blades with 40 teeth (40T). The blades are stacked offset in the packs. The packaging is blue, orange and yellow and has the words "Irwin" and "Classic Series" on the front top left corner and "3 Circular Saw Blades" on the front lower left corner. Model number "ICSLD3PK" is located on the front top right corner.. Recalled by Irwin Industrial Tool Company, Huntersville, N.c.. Units affected: About 55,260.
Why was this product recalled? ▼
The saw blades can fall out of the bottom of the plastic packaging, posing a laceration hazard.
What should consumers do? ▼
Consumers should immediately contact the firm to receive a free storage container for the saw blades. Consumers should not disturb any saw blades that remain in the packaging but should store the saw blades in the packaging in a safe and secure location until the container arrives, then immediately transfer the saw blades to the container and discard the original packaging.
Which agency issued this recall? ▼
This recall was issued by the CPSC on April 19, 2012. Severity: Moderate. Recall number: 12154.
How do I check if my product is affected by a recall? ▼
Check the product description and recall number (12154) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product? ▼
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.
Nearby Recalls in This Category
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
CPSC Moderate
Cooper Lighting Recalls Metalux Optimized High Bay LED Light Fixtures Due to Fire Hazard
Cooper Lighting, LLC, of Peachtree City, Georgia · 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Roman Candles 8 Shot Fireworks Due to Risk of Serious Injury from Explosion and B…
· 2026-07-02
CPSC Moderate
Winco Fireworks International Recalls Unity 7 Shot 200 Gram Aerial Cake Fireworks Due to Risk of Serious Injury from Ex…
· 2026-07-02
CPSC Moderate
Kith Retail Recalls Children's Loungewear Sets Due to Risk of Serious Injury from Burn Hazard; Violate Mandatory Standa…
· 2026-06-25
CPSC Moderate
Southern Telecom Expands Recall of Lomi Waxing Kits Due to Risk of Serious Injury or Death from Fire and Burn Hazards; …
· 2026-06-25
Compare this recall with Cooper Lighting Recalls Metalux Optimized High Bay LED Ligh… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported April 19, 2012. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.