PlainRecalls
No agency classActive

CPSC recall · Reported June 21, 2012

Flushmate Recalls Flushmate® III Pressure-Assisted Flushing System Due to Impact and Laceration Hazards

The system can burst at or near the vessel weld seam releasing stored pressure. This pressure can lift the tank lid and shatter the tank, posing impact or laceration hazards to co…

Recall #
12201
Affected scope
About 2,330,600 in the U.S. and 9,400 in Canada
Verify with CPSC →
View my saved recalls

Flushmate, of New Hudson, Mich., a division of Sloan Valve Company recalled This recall is for Series 503 Flushmate® III Pressure Assist flushing systems installed i….

Flushmate Recalls Flushmate® III Pressure-Assisted Flushing System Due to Impact and Lace… was recalled by Flushmate, of New Hudson, Mich., a division of Sloan Valve Company in June 21, 2012. Reason: The system can burst at or near the vessel weld seam releasing stored pressure. This pressure can lift the ta…. Remedy: Consumers should immediately turn off the water supply to the recalled Flushmate III unit…. Verify recall #12201 with the CPSC before acting.

The recall

Flushmate, of New Hudson, Mich., a division of Sloan Valve Company issued this CPSC recall-The system can burst at or near the vessel weld seam releasing stored pressure. This pressure can lift the ta….

None
agency class
June 21, 2012
reported

Sourced from official CPSC enforcement records. Verify recall #12201 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Drugs & Medications recalls over time

Where this recall sits in its category - 14,472 drugs & medications recalls on record

05001,0001,5002,000 2006201220152018202120242026 448

Product description

This recall is for Series 503 Flushmate® III Pressure Assist flushing systems installed inside toilet tanks. The recalled systems were manufactured from October 1997 to February 2008. The units are rectangular, black, two-piece vessels made of injection molded plastic. The date code/serial number is 16 characters long and is located on the label on the top of the Flushmate III. The first six numerals of the serial number are the date code. The date code range for this recall begins with 101497 (October 14, 1997) and continues through 022908 (February 29, 2008).

Reason for recall

The system can burst at or near the vessel weld seam releasing stored pressure. This pressure can lift the tank lid and shatter the tank, posing impact or laceration hazards to consumers and property damage.

Remedy, what to do

Consumers should immediately turn off the water supply to the recalled Flushmate III unit and stop using the system. Consumers should contact the firm to determine if their Flushmate III serial number is included in the recall and to request a free repair kit.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 12201
Date reported June 21, 2012
Date initiated June 21, 2012
Recalling firm Flushmate, of New Hudson, Mich., a division of Sloan Valve Company
Affected scope About 2,330,600 in the U.S. and 9,400 in Canada
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should immediately turn off the water supply to the recalled Flushmate III unit and stop using the system. Consumers sh…

  • Check the recall number (12201) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
This recall is for Series 503 Flushmate® III Pressure Assist flushing systems installed inside toilet tanks. The recalled systems were manufactured from October 1997 to February 2008. The units are rectangular, black, two-piece vessels made of injection molded plastic. The date code/serial number is 16 characters long and is located on the label on the top of the Flushmate III. The first six numerals of the serial number are the date code. The date code range for this recall begins with 101497 (October 14, 1997) and continues through 022908 (February 29, 2008).. Recalled by Flushmate, of New Hudson, Mich., a division of Sloan Valve Company. Units affected: About 2,330,600 in the U.S. and 9,400 in Canada.
Why was this product recalled?
The system can burst at or near the vessel weld seam releasing stored pressure. This pressure can lift the tank lid and shatter the tank, posing impact or laceration hazards to consumers and property damage.
What should consumers do?
Consumers should immediately turn off the water supply to the recalled Flushmate III unit and stop using the system. Consumers should contact the firm to determine if their Flushmate III serial number is included in the recall and to request a free repair kit.
Which agency issued this recall?
This recall was issued by the CPSC on June 21, 2012. CPSC does not publish a hazard classification for this recall. Recall number: 12201.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with Kian Pee Wan Capsules, 30-count bottles → · All Drugs & Medications recalls

This recall: CPSC, reported June 21, 2012. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026