PlainRecalls

Fu San Machinery Recalls Low Lead Ball Valves Installed in Flammable Gas Lines Due to Fire and Explosion Hazards

Reported: December 11, 2012 Initiated: December 11, 2012 #13064 About 163,000 units

Fu San Machinery Co. Ltd., of Taiwan issued this CPSC recall on December 11, 2012. Classified as Moderate severity. Approximately About 163,000 units are affected. The recall was issued because: The valves can crack and cause gas to leak. This poses fire and explosion hazards.. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #13064) was formally reported on December 11, 2012. It is classified under Moderate severity, with a current status of Active. Fu San Machinery Co. Ltd., of Taiwan is listed as the recalling firm. Federal records indicate About 163,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: The valves can crack and cause gas to leak. This poses fire and explosion hazards. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should turn off the gas supply until a replacement gas valve has been professionally installed. Consumers should contact Danville Sales which, on behalf of Fu San Machinery, will provide co… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 14 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 163,000

Related Recalls

6

6 from same agency

Product Description

This recall involves seven brands of sweat and threaded, low lead ball valves used in flammable gas piping systems used in commercial or residential settings. They are brass shut-off valves assembled with pipe lines of ¾ inch and 1 inch and have a date code 1103 through 1112, in YYMM format, where YY is the year and MM is the month. The date code is located under the valve handle. The pipe size is marked on the body of the valve. Fu San's logo and the "O" marking designated for low lead valves are marked on the valves' neck under where the handle assembles. The word "Taiwan" appears on the handle as a country of origin marking. The valves were sold under the following brand names and model numbers: Brand Name Model Number Valve Dimensions/Sweat or Threaded Valves Aqualine BBV-075-LF ¾ inch/Threaded BBV-075S-LF ¾ inch/Sweat BBV-100-LF 1 inch/Threaded BBV-100S-LF 1 inch/Sweat AY McDonald 72032S ¾ inch/Sweat 72032T ¾ inch/Threaded FNW FNWX410AF ¾ inch/Threaded FNWX410AG 1 inch/Threaded FNWX411F ¾ inch/Sweat FNWX411G 1 inch/Sweat Hodes Co. 40-642 1 inch/Threaded 40-662 1 inch /Threaded 40-677 ¾ inch/Sweat 40-687 ¾ inch/Sweat 40-678 1 inch/Sweat 40-688 1 inch/Sweat Legend T1002NL 1 inch/Threaded Leonard Valve 83503 ¾ inch/Sweat 83504 1 inch/Sweat 83538 ¾ inch/Threaded 83539 1 inch/Threaded Mueller 107-844NL ¾ inch/Sweat

Reason for Recall

The valves can crack and cause gas to leak. This poses fire and explosion hazards.

Remedy

Consumers should turn off the gas supply until a replacement gas valve has been professionally installed. Consumers should contact Danville Sales which, on behalf of Fu San Machinery, will provide compensation of $300 to reimburse customers for costs incurred to remove and return the valve and for purchasing and installing a replacement valve. The affected valve should be returned to the Danville Sales Office for Fu San Machinery with a photo depicting the valve in the gas line before removal and showing the date code on the valve, along with the address and details of the location where the valve was installed. The requested information, the recalled valve, and the consumer name and address should be sent to the address in the Consumer Contact paragraph. Upon receipt, Fu San will reimburse customers in the amount of $300.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 13064
Date reported December 11, 2012
Date initiated December 11, 2012
Recalling firm Fu San Machinery Co. Ltd., of Taiwan
Units affected About 163,000
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 163,000 units affected — multi-state distribution scale.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units) ✓ This recall
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves seven brands of sweat and threaded, low lead ball valves used in flammable gas piping systems used in commercial or residential settings. They are brass shut-off valves assembled with pipe lines of ¾ inch and 1 inch and have a date code 1103 through 1112, in YYMM format, where YY is the year and MM is the month. The date code is located under the valve handle. The pipe size is marked on the body of the valve. Fu San's logo and the "O" marking designated for low lead valves are marked on the valves' neck under where the handle assembles. The word "Taiwan" appears on the handle as a country of origin marking. The valves were sold under the following brand names and model numbers: Brand Name Model Number Valve Dimensions/Sweat or Threaded Valves Aqualine BBV-075-LF ¾ inch/Threaded BBV-075S-LF ¾ inch/Sweat BBV-100-LF 1 inch/Threaded BBV-100S-LF 1 inch/Sweat AY McDonald 72032S ¾ inch/Sweat 72032T ¾ inch/Threaded FNW FNWX410AF ¾ inch/Threaded FNWX410AG 1 inch/Threaded FNWX411F ¾ inch/Sweat FNWX411G 1 inch/Sweat Hodes Co. 40-642 1 inch/Threaded 40-662 1 inch /Threaded 40-677 ¾ inch/Sweat 40-687 ¾ inch/Sweat 40-678 1 inch/Sweat 40-688 1 inch/Sweat Legend T1002NL 1 inch/Threaded Leonard Valve 83503 ¾ inch/Sweat 83504 1 inch/Sweat 83538 ¾ inch/Threaded 83539 1 inch/Threaded Mueller 107-844NL ¾ inch/Sweat. Recalled by Fu San Machinery Co. Ltd., of Taiwan. Units affected: About 163,000.
Why was this product recalled?
The valves can crack and cause gas to leak. This poses fire and explosion hazards.
What should consumers do?
Consumers should turn off the gas supply until a replacement gas valve has been professionally installed. Consumers should contact Danville Sales which, on behalf of Fu San Machinery, will provide compensation of $300 to reimburse customers for costs incurred to remove and return the valve and for purchasing and installing a replacement valve. The affected valve should be returned to the Danville Sales Office for Fu San Machinery with a photo depicting the valve in the gas line before removal and showing the date code on the valve, along with the address and details of the location where the valve was installed. The requested information, the recalled valve, and the consumer name and address should be sent to the address in the Consumer Contact paragraph. Upon receipt, Fu San will reimburse customers in the amount of $300.
Which agency issued this recall?
This recall was issued by the CPSC on December 11, 2012. Severity: Moderate. Recall number: 13064.
How do I check if my product is affected by a recall?
Check the product description and recall number (13064) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Electrolux Group Recalls Frigidaire Gas Ranges Due to Burn … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).