Severity
Moderate
Visonic Recalls Amber Personal Emergency Response System Kits Due to Remote Pendant Battery Signal Failure
Reported: September 11, 2013 Initiated: September 11, 2013 #13280 About 24,000 units
Visonic Ltd., of Tel Aviv, Israel issued this CPSC recall on September 11, 2013. Classified as Moderate severity. Approximately About 24,000 units are affected. The recall was issued because: A single Amber Base station set to Common Area Mode will not detect a low battery or dead battery warning signal from t…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.
Recall Insight
This CPSC action (record #13280) was formally reported on September 11, 2013. It is classified under Moderate severity, with a current status of Active. Visonic Ltd., of Tel Aviv, Israel is listed as the recalling firm. Federal records indicate About 24,000 units are affected.
The documented reason for this recall is: A single Amber Base station set to Common Area Mode will not detect a low battery or dead battery warning signal from the remote pendant that notifies the end user or system administrator to replace the pendant battery. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately contact their system installer or a Visonic alarm installation professional to determine if their Amber base station is set to Common Area Mode, and if so, to either rese… — consumers holding this product should act on that instruction rather than relying on general guidance.
To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 13 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.
Recall Distribution by Severity Class
Units Affected
About 24,000
Related Recalls
6
6 from same agency
Product Description
The recalled Visonic Amber Personal Emergency Response System (PERS) kit enables a user to push a button on a pendant to signal a request for assistance. An Amber kit consists of one wireless pendant worn by the user, one Amber brand base station, generally connected to a phone line, a power supply and backup battery. Base stations are white, rectangular and measure about 9 inches wide by 7 inches deep by 2 inches high with emergency, call and check buttons. The emergency button is red on the Classic model and grey on the SelectX model. Recalled Classic models have catalog number 0-7425 and serial numbers 0408044281 through 4410052723. The first four digits of the serial number are manufacture dates from January 2008 through August 2010 in WWYY format. Recalled SelectX models have catalog number 0-100729 and serial numbers 2308600299 through 3013079617 The first four digits represent manufacture dates June 2008 through July 2013 in WWYY format. The first two digits are week of manufacture and the second two numbers are the year of manufacture. For example serial number 2308 600299 indicates a manufacturing date of the 23rd week of 2008 or roughly June 2008. Each unit has an external label on the back of the base station, with the product name and serial number. Only Amber Classic or SelectX base stations that are placed in Common Area Mode by a professionally trained PERS system installer and are used without additional base stations, are included in the recall.
Reason for Recall
A single Amber Base station set to Common Area Mode will not detect a low battery or dead battery warning signal from the remote pendant that notifies the end user or system administrator to replace the pendant battery.
Remedy
Consumers should immediately contact their system installer or a Visonic alarm installation professional to determine if their Amber base station is set to Common Area Mode, and if so, to either reset their unit to another mode or make other system changes, such as adding an additional base station. Only a professionally-trained PERS system installer can identify and modify the particular mode configuration. Owners are also reminded to manually test their Amber PERS pendant regularly for low battery status.
Details
- Recalling Firm
- Visonic Ltd., of Tel Aviv, Israel
- Units Affected
- About 24,000
Recall Profile
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 13280 |
| Date reported | September 11, 2013 |
| Date initiated | September 11, 2013 |
| Recalling firm | Visonic Ltd., of Tel Aviv, Israel |
| Units affected | About 24,000 |
| Distribution | Not disclosed |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
Frequently Asked Questions
What product was recalled? ▼
The recalled Visonic Amber Personal Emergency Response System (PERS) kit enables a user to push a button on a pendant to signal a request for assistance. An Amber kit consists of one wireless pendant worn by the user, one Amber brand base station, generally connected to a phone line, a power supply and backup battery. Base stations are white, rectangular and measure about 9 inches wide by 7 inches deep by 2 inches high with emergency, call and check buttons. The emergency button is red on the Classic model and grey on the SelectX model. Recalled Classic models have catalog number 0-7425 and serial numbers 0408044281 through 4410052723. The first four digits of the serial number are manufacture dates from January 2008 through August 2010 in WWYY format. Recalled SelectX models have catalog number 0-100729 and serial numbers 2308600299 through 3013079617 The first four digits represent manufacture dates June 2008 through July 2013 in WWYY format. The first two digits are week of manufacture and the second two numbers are the year of manufacture. For example serial number 2308 600299 indicates a manufacturing date of the 23rd week of 2008 or roughly June 2008. Each unit has an external label on the back of the base station, with the product name and serial number. Only Amber Classic or SelectX base stations that are placed in Common Area Mode by a professionally trained PERS system installer and are used without additional base stations, are included in the recall.. Recalled by Visonic Ltd., of Tel Aviv, Israel. Units affected: About 24,000.
Why was this product recalled? ▼
A single Amber Base station set to Common Area Mode will not detect a low battery or dead battery warning signal from the remote pendant that notifies the end user or system administrator to replace the pendant battery.
What should consumers do? ▼
Consumers should immediately contact their system installer or a Visonic alarm installation professional to determine if their Amber base station is set to Common Area Mode, and if so, to either reset their unit to another mode or make other system changes, such as adding an additional base station. Only a professionally-trained PERS system installer can identify and modify the particular mode configuration. Owners are also reminded to manually test their Amber PERS pendant regularly for low battery status.
Which agency issued this recall? ▼
This recall was issued by the CPSC on September 11, 2013. Severity: Moderate. Recall number: 13280.
How do I check if my product is affected by a recall? ▼
Check the product description and recall number (13280) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product? ▼
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.
Recall Guides
Learn how the US recall system works and how to protect yourself and your household.
How the US Recall System Works
The three federal agencies, how recalls are initiated, and what happens next.
Understanding Recall Severity Classes
What Class I, II, and III mean and which recalls demand immediate action.
What to Do When a Product Is Recalled
Verify, claim your remedy, report injuries, and navigate the process.
How to Check If Your Products Are Recalled
Step-by-step guide to checking food, products, medications, and vehicles.
Recalled Products in Your Home
A room-by-room household audit guide for active recalls.
Most Recalled Product Categories
Rankings of highest-recall categories from FDA, CPSC, and NHTSA.
Recall Context
Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.
Related Safety Data
Explore related product safety and public health data from federal sources.
Food Safety Inspections
FDA and state food facility inspection results — violations, enforcement actions, and compliance history for food manufacturers and processors.
PlainFoodSafe →
Ingredient Safety Data
FDA food additive and ingredient safety database — regulatory status, usage limits, and safety assessments for thousands of ingredients.
PlainIngredients →
Nutrition Data
USDA nutrition facts for 2M+ food items — calories, macros, vitamins, and ingredient analysis to verify what you consume.
GetFoodFacts →
Drug Safety Information
FDA drug data for 680+ medications — interactions, alternatives, side effects, and safety information for recalled and active drugs.
PlainMeds →
Product Injury Data
CPSC emergency room injury data for 838 product categories — 7.3M NEISS records tracking real-world consumer product injuries.
PlainSafety →
Recall Checker
Search our database of 83K+ recalls by product name, brand, or recall number across all agencies.
Check Now →
Recall Radar
Live feed of the latest recalls across FDA, CPSC, NHTSA, and USDA — filter by agency and severity.
View Radar →
Nearby Recalls in This Category
Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.
CPSC Moderate
LShome Photoelectric Smoke Detector Fire Alarms Recalled Due Failure to Warn During Fire Posing Serious Injury or Death…
TIANJINSHIHAOWEIXINSHENGJIDIANANZHUANGGONGCHENG, of China · 2026-02-12
CPSC Moderate
Energizer Recalls Rechargeable Lanterns Due to Overheating
· 2026-01-15
CPSC Moderate
Belkin Recalls Portable Power Banks and Wireless Charging Stands Due to Fire and Burn Hazards
Belkin International Inc., of El Segundo, California · 2025-11-13
CPSC Moderate
Tesla Recalls Powerwall 2 AC Battery Power Systems Due to Fire and Burn Hazards; Risk of Serious Injury or Death
Tesla, Inc., of Reno, Nevada · 2025-11-13
CPSC Moderate
ESR HaloLock Wireless Power Banks Recall Expanded to Include Additional Model Due to Risk of Serious Burn Injury and Fi…
Waymeet Limited, of Hong Kong · 2025-10-09
Compare this recall with LShome Photoelectric Smoke Detector Fire Alarms Recalled Du… →
Data Sources
Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.
- Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
- Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
- Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
- Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)
Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.
Read our methodology — how this data is sourced, computed, and verified.
All federal data sources used on this page
- U.S. Census Bureau ACS — demographic + housing + income data. census.gov/programs-surveys/acs
- BLS Occupational Employment and Wage Statistics (OEWS) — wage + employment by occupation. bls.gov/oes
- BEA Regional Economic Accounts — GDP + personal income by state/metro. bea.gov/data/regional
- U.S. Census Bureau County Business Patterns — establishment + employment by industry. census.gov/cbp
- IRS Statistics of Income (SOI) — tax-return aggregate data. irs.gov/statistics
- data.gov — U.S. federal open-data portal — discovery layer for additional federal sources. data.gov
Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).