Severity
Moderate
CPSC recall · Reported December 18, 2013
The suspension fork's damper cylinder/piston can separate and cause the front wheel to detach, posing a fall hazard.
Fox Factory, of Watsonville, Calif. recalled The recalled suspension forks are model year 2013, 32 and 34 Evolution Series with 120mm … - a moderate-severity action.
Fox Factory Recalls Evolution Mountain Bike Suspension Forks Due to Fall Hazard was recalled by Fox Factory, of Watsonville, Calif. in December 18, 2013. Reason: The suspension fork's damper cylinder/piston can separate and cause the front wheel to detach, posing a fall …. Remedy: Consumers should stop using the bicycles with recalled Fox Factory suspension forks and b…. Verify recall #14063 with the CPSC before acting.
The recall
Fox Factory, of Watsonville, Calif. issued this moderate-severity CPSC recall-The suspension fork's damper cylinder/piston can separate and cause the front wheel to detach, posing a fall ….
Sourced from official CPSC enforcement records. Verify recall #14063 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
This CPSC action (record #14063) was formally reported on December 18, 2013. It is classified under Moderate severity, with a current status of Active. Fox Factory, of Watsonville, Calif. is listed as the recalling firm. Federal records list the affected scope as About 11,250 in the U.S. and 1,250 in Canada.
The documented reason for this recall is: The suspension fork's damper cylinder/piston can separate and cause the front wheel to detach, posing a fall hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the bicycles with recalled Fox Factory suspension forks and bring them to the place of purchase for a free repair. Consumers can check their serial number at www.ridefox.c… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Where this recall sits in its category - 510 outdoor & sports recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Severity
Moderate
Affected scope
About 11,250 in the U.S. and 1,250 in Canada
Related Recalls
6
6 from same agency
The recalled suspension forks are model year 2013, 32 and 34 Evolution Series with 120mm to 160mm of travel. The Evolution name and logo are on a sticker on the front fork with the FOX brand name logo. Recalled forks can be identified by the serial number, which is found on the underside of the crown after removing the front wheel. The forks were sold as original equipment on some of the following 2013 model year mountain bikes: BMC, Cannondale, Commencal, Diamondback, GT, Kona, Lapierre, Norco, Orbea, Raleigh, Rocky Mountain, Santa Cruz, Scott, Specialized and Trek. A small quantity of suspension forks were sold to retailers or distributors as aftermarket accessories.
The suspension fork's damper cylinder/piston can separate and cause the front wheel to detach, posing a fall hazard.
Consumers should stop using the bicycles with recalled Fox Factory suspension forks and bring them to the place of purchase for a free repair. Consumers can check their serial number at www.ridefox.com/, see the link at the lower left of the page, or contact Fox for assistance with discerning whether their bicycle has the recalled product and for instructions on how to return the recalled product and receive the free repair if they cannot bring their bicycle or fork to the place of purchase.
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 14063 |
| Date reported | December 18, 2013 |
| Date initiated | December 18, 2013 |
| Recalling firm | Fox Factory, of Watsonville, Calif. |
| Affected scope | About 11,250 in the U.S. and 1,250 in Canada |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should stop using the bicycles with recalled Fox Factory suspension forks and bring them to the place of purchase for a…
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
Changsha Jiali Duo Technology Co., Ltd., dba Topyond, of China · 2026-07-02
Shenzhen Fuxiangyue Technology Co., Ltd., dba Arrogantf, of China · 2026-06-18
Foshan Nanhai District Haichen Tengfei Hardware Factory, of China · 2026-06-11
· 2026-06-11
Dongguanshizhouhedianzishangwuyouxiangongsi (Dongguan Zhouhe E-commerce Co., Ltd.) dba Gudook Outdoor Sports, of China · 2026-06-04
Compare this recall with Topyond Pool Drain Ports with Covers Recalled Due to Risk o… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported December 18, 2013. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.