Severity
Moderate
ModerateActive
CPSC recall · Reported July 2, 2014
Porter-Cable Fixed-Base Production Routers Recalled Due to Electrical Shock Hazard
The router base handles are not insulated, posing an electric shock hazard.
Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md. recalled Four Porter-Cable 3 1/4 horsepower, electric, fixed-base production routers and one produ… - a moderate-severity action.
Porter-Cable Fixed-Base Production Routers Recalled Due to Electrical Shock Hazard was recalled by Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md. in July 2, 2014. Reason: The router base handles are not insulated, posing an electric shock hazard.. Remedy: Consumers should immediately stop using the recalled routers and router bases, unplug the…. Verify recall #14221 with the CPSC before acting.
The recall
Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md. issued this moderate-severity CPSC recall-The router base handles are not insulated, posing an electric shock hazard..
- Moderate
- severity level
- July 2, 2014
- reported
Sourced from official CPSC enforcement records. Verify recall #14221 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
This CPSC action (record #14221) was formally reported on July 2, 2014. It is classified under Moderate severity, with a current status of Active. Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md. is listed as the recalling firm. Federal records list the affected scope as About 100,000 in the United States and about 7,800 in Canada.
The documented reason for this recall is: The router base handles are not insulated, posing an electric shock hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled routers and router bases, unplug the routers and contact Porter-Cable for a free replacement router base with insulation on the handles. - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Electronics recalls over time
Where this recall sits in its category - 609 electronics recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Affected scope
About 100,000 in the United States and about 7,800 in Canada
Related Recalls
6
6 from same agency
Product description
Four Porter-Cable 3 1/4 horsepower, electric, fixed-base production routers and one production router base are being recalled. The recalled routers are about 11 inches tall and 7 inches wide. The top of the router motor is black plastic and has the on/off switch for the router. The base is painted gray and has two side handles, an adjuster ring on the top and a clamp screw on the rear. The side handles on the base of recalled routers have no insulation. The Porter-Cable name and logo are on the front of the base. The recalled routers and base were manufactured from 1990 to April 2014. The following router models are being recalled: Model Number Speed/Feature 7518 5-speed 7519 1-speed 7519EC 1-speed/has an extended chuck 22-7519-60 1-speed/ uses 220-volt power source The router model number and the manufacture date code are on a metal plate on the back of the upper motor housing. The date code consists of the year of manufacture, the week of manufacture and the manufacturing plant code in the YYYY WW-XX format. The router base is model number 75361 and is also sold separately. The model number is located on the side of the base opposite the Porter-Cable label.
Reason for recall
The router base handles are not insulated, posing an electric shock hazard.
Remedy, what to do
Consumers should immediately stop using the recalled routers and router bases, unplug the routers and contact Porter-Cable for a free replacement router base with insulation on the handles.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 14221 |
| Date reported | July 2, 2014 |
| Date initiated | July 2, 2014 |
| Recalling firm | Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md. |
| Affected scope | About 100,000 in the United States and about 7,800 in Canada |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should immediately stop using the recalled routers and router bases, unplug the routers and contact Porter-Cable for a …
- Check the recall number (14221) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
Four Porter-Cable 3 1/4 horsepower, electric, fixed-base production routers and one production router base are being recalled. The recalled routers are about 11 inches tall and 7 inches wide. The top of the router motor is black plastic and has the on/off switch for the router. The base is painted gray and has two side handles, an adjuster ring on the top and a clamp screw on the rear. The side handles on the base of recalled routers have no insulation. The Porter-Cable name and logo are on the front of the base. The recalled routers and base were manufactured from 1990 to April 2014. The following router models are being recalled: Model Number Speed/Feature 7518 5-speed 7519 1-speed 7519EC 1-speed/has an extended chuck 22-7519-60 1-speed/ uses 220-volt power source The router model number and the manufacture date code are on a metal plate on the back of the upper motor housing. The date code consists of the year of manufacture, the week of manufacture and the manufacturing plant code in the YYYY WW-XX format. The router base is model number 75361 and is also sold separately. The model number is located on the side of the base opposite the Porter-Cable label.. Recalled by Black & Decker (U.S.) Inc., dba Porter-Cable, Towson, Md.. Units affected: About 100,000 in the United States and about 7,800 in Canada.
Why was this product recalled? ▼
The router base handles are not insulated, posing an electric shock hazard.
What should consumers do? ▼
Consumers should immediately stop using the recalled routers and router bases, unplug the routers and contact Porter-Cable for a free replacement router base with insulation on the handles.
Which agency issued this recall? ▼
This recall was issued by the CPSC on July 2, 2014. Severity: Moderate. Recall number: 14221.
How do I check if my product is affected by a recall? ▼
Check the product description and recall number (14221) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product? ▼
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.
Nearby Recalls in This Category
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
CPSC Moderate
Projecting LED Finger Light Toys Recalled Due to Risk of Serious Injury Death from Battery Ingestion; Violate Mandatory…
Shenzhen Bopu Product Design Co., Ltd., dba POPOOO, of China · 2026-07-02
CPSC Moderate
Combination Smoke and Carbon Monoxide (CO) Detectors Recalled Due to Risk of Serious Injury or Death from Failure to Al…
· 2026-06-25
CPSC Moderate
Raychy Children's Light Sneakers Recalled Due to Risk of Serious Injury or Death from Battery Ingestion; Violate Mandat…
· 2026-06-25
CPSC Moderate
Super Off-Road Solar Power Banks Recalled Due to Overheating; Imported by Spector & Co.
· 2026-06-25
CPSC Moderate
School Specialty Recalls Tip Restraint Kits Included in Childcraft Furniture Due to Risk of Serious Injury or Death fro…
School Specialty, LLC, of Greenville, Wisconsin · 2026-06-11
Compare this recall with Projecting LED Finger Light Toys Recalled Due to Risk of Se… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported July 2, 2014. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.