PlainRecalls
No agency classActive

CPSC recall · Reported September 3, 2014

iDevices Recalls Temperature Probes Due to Ingestion Hazard

The plastic insulator located inside the stainless steel probe is not heat resistant and can melt and fall into food, posing an ingestion hazard.

Recall #
14267
Affected scope
About 48,500 in the U.S. and 510 in Canada
Verify with CPSC →
View my saved recalls

The CPSC recalled This recall involves all Pro Ambient Temperature Probes and Pro Meat Probes manufactured ….

iDevices Recalls Temperature Probes Due to Ingestion Hazard was recalled and listed by the CPSC in September 3, 2014. Reason: The plastic insulator located inside the stainless steel probe is not heat resistant and can melt and fall in…. Remedy: Consumers should immediately stop using the recalled temperature probes and contact iDevi…. Verify recall #14267 with the CPSC before acting.

The recall

issued this CPSC recall-The plastic insulator located inside the stainless steel probe is not heat resistant and can melt and fall in….

None
agency class
September 3, 2014
reported

Sourced from official CPSC enforcement records. Verify recall #14267 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Food recalls over time

Where this recall sits in its category - 25,457 food recalls on record

01,0002,0003,000 20052008201120142017202020232026 813

Product description

This recall involves all Pro Ambient Temperature Probes and Pro Meat Probes manufactured from May 2014 through June 2014. The probes were sold separately as an accessory for the iGrill, iGrill2, iGrillmini grilling thermometers and the Kitchen Thermometer and Kitchen Thermometer mini cooking thermometers. The meat probe was also sold as a component of the iGrill2 set. The probes consist of a curved stainless steel rod attached to a mini connector by a steel braided cable. Pro Ambient Temperature probes are about 6 inches long with a metal grate clip on the end. Pro Meat Probes are about 6 3/4 inches long. iGrill Pro Meat Probes and iGrill Pro Ambient Probes came with either a red or yellow rubber sleeve and an oval black plastic cord holder. Kitchen Thermometer Pro Meat Probes and Kitchen Thermometer Pro Ambient Probes came with a green rubber sleeve and a round white plastic cord holder. The iDevices logo is stamped into the top of the cord holder. Recalled probes have only two indentations, or crimps, in the base of the probe tube where attached to the braided cable. iGrill Pro Meat Probes and iGrill Pro Ambient Probes came in red packaging. Kitchen Thermometer Pro Meat Probes and Kitchen Thermometer Pro Ambient Probes came in green packaging. The iDevices name and logo and either "iGrill Pro Meat Probe," "iGrill Pro Ambient Temperature Probe," "Kitchen Thermometer Pro Meat Probe" or "Kitchen Thermometer Pro Ambient Probe" are printed on the front of the packaging. UPC number 852931005148, 852931005193, 852931005162 or 852931005216 is printed on the bottom of the packaging.

Reason for recall

The plastic insulator located inside the stainless steel probe is not heat resistant and can melt and fall into food, posing an ingestion hazard.

Remedy, what to do

Consumers should immediately stop using the recalled temperature probes and contact iDevices for a free replacement.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 14267
Date reported September 3, 2014
Date initiated September 3, 2014
Recalling firm Not disclosed
Affected scope About 48,500 in the U.S. and 510 in Canada
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should immediately stop using the recalled temperature probes and contact iDevices for a free replacement.

  • Check the recall number (14267) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
This recall involves all Pro Ambient Temperature Probes and Pro Meat Probes manufactured from May 2014 through June 2014. The probes were sold separately as an accessory for the iGrill, iGrill2, iGrillmini grilling thermometers and the Kitchen Thermometer and Kitchen Thermometer mini cooking thermometers. The meat probe was also sold as a component of the iGrill2 set. The probes consist of a curved stainless steel rod attached to a mini connector by a steel braided cable. Pro Ambient Temperature probes are about 6 inches long with a metal grate clip on the end. Pro Meat Probes are about 6 3/4 inches long. iGrill Pro Meat Probes and iGrill Pro Ambient Probes came with either a red or yellow rubber sleeve and an oval black plastic cord holder. Kitchen Thermometer Pro Meat Probes and Kitchen Thermometer Pro Ambient Probes came with a green rubber sleeve and a round white plastic cord holder. The iDevices logo is stamped into the top of the cord holder. Recalled probes have only two indentations, or crimps, in the base of the probe tube where attached to the braided cable. iGrill Pro Meat Probes and iGrill Pro Ambient Probes came in red packaging. Kitchen Thermometer Pro Meat Probes and Kitchen Thermometer Pro Ambient Probes came in green packaging. The iDevices name and logo and either "iGrill Pro Meat Probe," "iGrill Pro Ambient Temperature Probe," "Kitchen Thermometer Pro Meat Probe" or "Kitchen Thermometer Pro Ambient Probe" are printed on the front of the packaging. UPC number 852931005148, 852931005193, 852931005162 or 852931005216 is printed on the bottom of the packaging.. Units affected: About 48,500 in the U.S. and 510 in Canada.
Why was this product recalled?
The plastic insulator located inside the stainless steel probe is not heat resistant and can melt and fall into food, posing an ingestion hazard.
What should consumers do?
Consumers should immediately stop using the recalled temperature probes and contact iDevices for a free replacement.
Which agency issued this recall?
This recall was issued by the CPSC on September 3, 2014. CPSC does not publish a hazard classification for this recall. Recall number: 14267.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with Grade A White In-shell Chicken eggs packaged in the followi… → · All Food recalls

This recall: CPSC, reported September 3, 2014. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026