PlainRecalls

Siemens Recalls Audible Fire Alarm Base Due to Risk of Injury

Reported: September 18, 2014 Initiated: September 18, 2014 #14278 About 9,000 units

Beijing Siemens Cerberus Electronics Ltd., of China issued this CPSC recall on September 18, 2014. Classified as Moderate severity. Approximately About 9,000 units are affected. The recall was issued because: The fire alarm base can fail to sound an alarm, posing a risk of personal injury and property damage.. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #14278) was formally reported on September 18, 2014. It is classified under Moderate severity, with a current status of Active. Beijing Siemens Cerberus Electronics Ltd., of China is listed as the recalling firm. Federal records indicate About 9,000 units are affected.

The documented reason for this recall is: The fire alarm base can fail to sound an alarm, posing a risk of personal injury and property damage. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately contact Siemens to schedule a free inspection and replacement of the recalled audible base. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 12 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 9,000

Related Recalls

6

0 from same agency

Product Description

This recall involves the SBGA-34 audible base that is affixed to ceiling-mounted smoke detectors in order to sound an alarm when the fire alarm system is activated. The audible base has part number S54370-F13 and date codes 0113 through 2314 in a WWYY format printed on a white label on the back of the unit part affixed to the wall. "MODEL SBGA-34" is printed on a blue label also affixed to the back of the device. The base is off-white and measures about 6 inches in diameter. The audible base is used with the following fire detectors: • Cerberus PRO models (HI921, OOHC941, OOH941, OH921, OP921) • Desigo Fire Safety models (FDOOTC441, FDOOT441, FDO421, FDOT421, FDT421) • H-Series (HFP-11, HFPT-11, HFPO-11) • Faraday 87XX-Series, models (8713, 8712, 8710) The audible base and fire detectors are used with the following alarm systems: • Siemens model FireFinder® XLS via DLC 6312 Device Loop Card • Siemens model FS -250 • Desigo model FC2005, (50-point panel) • Desigo model FC2025, (252-point system) • Desigo model FC2050, (504-point system) • Cerberus PRO FC901, (50-point panel • Cerberus PRO FC922, (252-point system) • Cerberus PRO FC924, (504-point system) • Faraday models MPC-600 and MPC-7000

Reason for Recall

The fire alarm base can fail to sound an alarm, posing a risk of personal injury and property damage.

Remedy

Consumers should immediately contact Siemens to schedule a free inspection and replacement of the recalled audible base.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 14278
Date reported September 18, 2014
Date initiated September 18, 2014
Recalling firm Beijing Siemens Cerberus Electronics Ltd., of China
Units affected About 9,000
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 9,000 units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves the SBGA-34 audible base that is affixed to ceiling-mounted smoke detectors in order to sound an alarm when the fire alarm system is activated. The audible base has part number S54370-F13 and date codes 0113 through 2314 in a WWYY format printed on a white label on the back of the unit part affixed to the wall. "MODEL SBGA-34" is printed on a blue label also affixed to the back of the device. The base is off-white and measures about 6 inches in diameter. The audible base is used with the following fire detectors: • Cerberus PRO models (HI921, OOHC941, OOH941, OH921, OP921) • Desigo Fire Safety models (FDOOTC441, FDOOT441, FDO421, FDOT421, FDT421) • H-Series (HFP-11, HFPT-11, HFPO-11) • Faraday 87XX-Series, models (8713, 8712, 8710) The audible base and fire detectors are used with the following alarm systems: • Siemens model FireFinder® XLS via DLC 6312 Device Loop Card • Siemens model FS -250 • Desigo model FC2005, (50-point panel) • Desigo model FC2025, (252-point system) • Desigo model FC2050, (504-point system) • Cerberus PRO FC901, (50-point panel • Cerberus PRO FC922, (252-point system) • Cerberus PRO FC924, (504-point system) • Faraday models MPC-600 and MPC-7000. Recalled by Beijing Siemens Cerberus Electronics Ltd., of China. Units affected: About 9,000.
Why was this product recalled?
The fire alarm base can fail to sound an alarm, posing a risk of personal injury and property damage.
What should consumers do?
Consumers should immediately contact Siemens to schedule a free inspection and replacement of the recalled audible base.
Which agency issued this recall?
This recall was issued by the CPSC on September 18, 2014. Severity: Moderate. Recall number: 14278.
How do I check if my product is affected by a recall?
Check the product description and recall number (14278) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Endo-Model Replacement Plateau; Item Number: 15-0027/11; →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).