Husqvarna Recalls Craftsman Push Mowers Due to Injury Hazard; Sold Exclusively at Orchard Supply Hardware (Recall Alert)

Recall Insight

This CPSC action (record #14754) was formally reported on September 30, 2014. It is classified under Moderate severity, with a current status of Active. Husqvarna Consumer Outdoor Products N.A. Inc., of Charlotte, N.C. is listed as the recalling firm. Federal records indicate About 700 units are affected.

The documented reason for this recall is: The engine control/bail lever on the handle can fail, allowing the engine to run and the blades to rotate, posing an injury hazard to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the mower and contact the Husqvarna for a free repair. The company is directly contacting consumers. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 1 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 12 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.