NHTSA recall · Reported June 13, 2014
FORD 2009-2014: EQUIPMENT
Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, re…
Ford recalled Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pres….
FORD 2009-2014: EQUIPMENT was recalled by Ford in June 13, 2014. Reason: Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to deter…. Remedy: Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure s…. Verify recall #14V328000 with the NHTSA before acting.
The recall
Ford issued this NHTSA recall-Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to deter….
- None
- agency class
- June 13, 2014
- reported
Sourced from official NHTSA enforcement records. Verify recall #14V328000 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
Recall Insight
The number of affected units is not disclosed in the agency filing, which is common for drug and food recalls where lot-level tracking supersedes unit counts. Distribution scope (see Distribution below) directly affects the consumer exposure window and determines whether a recall remains regional or escalates into a nationwide advisory. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 3 from NHTSA - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Vehicles recalls over time
Where this recall sits in its category - 7,783 vehicles recalls on record
Product description
Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Reason for recall
Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Hazard
The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.
Remedy, what to do
Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 28, 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Recall Profile
| Attribute | Value |
|---|---|
| Agency | National Highway Traffic Safety Administration |
| Severity class | Not classified by agency |
| Status | Active |
| Recall number | 14V328000 |
| Date reported | June 13, 2014 |
| Date initiated | June 13, 2014 |
| Recalling firm | Ford |
| Affected scope | Not disclosed |
| Distribution | United States |
| Official source | NHTSA notice → |
Profile values are sourced directly from the official NHTSA enforcement record. Source: National Highway Traffic Safety Administration.
What to do with this recall
Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away fro…
- Check the recall number (14V328000) and product description against the item you own. Search the archive
- Confirm the current status and remedy on the official NHTSA notice before acting. NHTSA notice
- Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next
This page summarizes the official NHTSA record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Frequently Asked Questions
What product was recalled? ▼
Why was this product recalled? ▼
What should consumers do? ▼
Which agency issued this recall? ▼
Where was the recalled product distributed? ▼
How do I report an injury from a recalled product? ▼
Nationwide recalls with similar severity or category timing
Vehicle and equipment notices outside this manufacturer and filing state, matched by archive severity grade and report timing.
Similar severity · nearest report date
Same archive severity grade, closest by report date among other firms and states.
Similar Vehicles · nearest report date
Same product category, closest by report date among other firms and states (deduped against the severity set).
Compare this recall with KTM North America Recalls Off-Road Motorcycles Due to Risk … → · All Vehicles recalls
Methodology · Corrections · Archive as of August 2026