PlainRecalls

Bed Handles Inc Reannounces Recall of Adult Portable Bed Handles Following Report of Fourth Entrapment Death

Reported: October 7, 2015 Initiated: October 7, 2015 #16005 About 113,000 units

Bed Handles Inc., of Blue Springs, Mo. issued this CPSC recall on October 7, 2015. Classified as Moderate severity. Approximately About 113,000 units are affected. The recall was issued because: When attached to an adult's bed without the use of safety retention straps, the handle can shift out of place, creating…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #16005) was formally reported on October 7, 2015. It is classified under Moderate severity, with a current status of Active. Bed Handles Inc., of Blue Springs, Mo. is listed as the recalling firm. Federal records indicate About 113,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: When attached to an adult's bed without the use of safety retention straps, the handle can shift out of place, creating a dangerous gap between the bed handle and the side of the mattress. This poses a serious risk of e… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using all recalled bed handles that were sold without safety retention straps. Contact Bed Handles, Inc. for free safety retention straps to secure the bed handle to… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 11 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 113,000

Related Recalls

6

6 from same agency

Product Description

The recall involves adult portable bed handles that do not have safety retention straps to secure the bed handle to the bed frame to keep the bed handle from shifting out of place and creating a dangerous gap. Recalled models include the Original Bedside Assistant® (BA10W), the Travel Handles™ (BA11W) which is sold as a set of two bed handles, and the Adjustable Bedside Assistant® (AJ1). The L-shaped bed handles are made out of ¾ inch tubular steel, measure 20 inches wide, 16 to 20 inches tall and have 3 ft. poles that extend under the mattress. The Original Bedside Assistant® (BA10W) and the Travel Handles™ (BA11W) have a white handle with white poles that go under the mattress. The Adjustable Bedside Assistant® (AJ1) is gold in color and has a black cushioned foam handle. The bed handles are intended to assist adults with getting in and out of bed by giving them a bar to grip. Bed Handles, Inc. and the model number are printed on a white label on the bed handles.

Reason for Recall

When attached to an adult's bed without the use of safety retention straps, the handle can shift out of place, creating a dangerous gap between the bed handle and the side of the mattress. This poses a serious risk of entrapment, strangulation and death.

Remedy

Consumers should immediately stop using all recalled bed handles that were sold without safety retention straps. Contact Bed Handles, Inc. for free safety retention straps to secure the bed handle to the bed frame, new assembly and installation instructions for models BA10W, BA11W and AJ1 and a warning label to attach to the bed handles. The bed handles should be used only with the safety retention straps securely in place attaching the bed handle to the bed frame in order to prevent a gap.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 16005
Date reported October 7, 2015
Date initiated October 7, 2015
Recalling firm Bed Handles Inc., of Blue Springs, Mo.
Units affected About 113,000
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 113,000 units affected — multi-state distribution scale.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units) ✓ This recall
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
The recall involves adult portable bed handles that do not have safety retention straps to secure the bed handle to the bed frame to keep the bed handle from shifting out of place and creating a dangerous gap. Recalled models include the Original Bedside Assistant® (BA10W), the Travel Handles™ (BA11W) which is sold as a set of two bed handles, and the Adjustable Bedside Assistant® (AJ1). The L-shaped bed handles are made out of ¾ inch tubular steel, measure 20 inches wide, 16 to 20 inches tall and have 3 ft. poles that extend under the mattress. The Original Bedside Assistant® (BA10W) and the Travel Handles™ (BA11W) have a white handle with white poles that go under the mattress. The Adjustable Bedside Assistant® (AJ1) is gold in color and has a black cushioned foam handle. The bed handles are intended to assist adults with getting in and out of bed by giving them a bar to grip. Bed Handles, Inc. and the model number are printed on a white label on the bed handles.. Recalled by Bed Handles Inc., of Blue Springs, Mo.. Units affected: About 113,000.
Why was this product recalled?
When attached to an adult's bed without the use of safety retention straps, the handle can shift out of place, creating a dangerous gap between the bed handle and the side of the mattress. This poses a serious risk of entrapment, strangulation and death.
What should consumers do?
Consumers should immediately stop using all recalled bed handles that were sold without safety retention straps. Contact Bed Handles, Inc. for free safety retention straps to secure the bed handle to the bed frame, new assembly and installation instructions for models BA10W, BA11W and AJ1 and a warning label to attach to the bed handles. The bed handles should be used only with the safety retention straps securely in place attaching the bed handle to the bed frame in order to prevent a gap.
Which agency issued this recall?
This recall was issued by the CPSC on October 7, 2015. Severity: Moderate. Recall number: 16005.
How do I check if my product is affected by a recall?
Check the product description and recall number (16005) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Electrolux Group Recalls Frigidaire Gas Ranges Due to Burn … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).