Sure Signal Products Recalls Heat-Activated Fire Alarms Due to Failure to Alert Consumers of a Fire

Recall Insight

This CPSC action (record #16021) was formally reported on October 29, 2015. It is classified under Moderate severity, with a current status of Active. Sure Signal Products, Inc., of Garden Grove, Calif. is listed as the recalling firm. Federal records indicate About 375,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: A defective fusible link sensor (fuse) on the fire alarm can cause the alarm to fail to alert consumers of a fire. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately contact Sure Signal Products for free replacement fuses. A video with instructions on how to replace the fuse is available at http://SureSignalProducts.com. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 11 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.