PlainRecalls
No agency classActive

CPSC recall · Reported March 16, 2016

SRAM Recalls Zipp Bicycle Wheel Hubs Due to Crash and Injury Hazards

The hub flanges on the front hubs can fail, posing a crash and injury hazard.

Recall #
16122
Affected scope
About 54,000 (In addition, about 2,900 were sold in Canada)
Verify with CPSC →
View my saved recalls

Prodigy Group, of Mooresville, Ind. recalled This recall includes SRAM's Zipp bicycle wheel hubs. The model names of the affected hubs….

SRAM Recalls Zipp Bicycle Wheel Hubs Due to Crash and Injury Hazards was recalled by Prodigy Group, of Mooresville, Ind. in March 16, 2016. Reason: The hub flanges on the front hubs can fail, posing a crash and injury hazard.. Remedy: Consumers should immediately stop using bicycles equipped with the recalled front hubs an…. Verify recall #16122 with the CPSC before acting.

The recall

Prodigy Group, of Mooresville, Ind. issued this CPSC recall-The hub flanges on the front hubs can fail, posing a crash and injury hazard..

None
agency class
March 16, 2016
reported

Sourced from official CPSC enforcement records. Verify recall #16122 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Food recalls over time

Where this recall sits in its category - 25,457 food recalls on record

01,0002,0003,000 20052008201120142017202020232026 813

Product description

This recall includes SRAM's Zipp bicycle wheel hubs. The model names of the affected hubs are ZIPP 88v6, 88v7 and 88v8. The Z logo is printed on the hub. The wheel hubs come in black, silver and falcon grey. The diameter of the clinch nut is approximately 1.46 inches. Some of the hubs were sold as part of wheel sets installed on new bicycles. SRAM will post a list of affected bicycle brands and models on its website at www.sram.com.

Reason for recall

The hub flanges on the front hubs can fail, posing a crash and injury hazard.

Remedy, what to do

Consumers should immediately stop using bicycles equipped with the recalled front hubs and contact SRAM or local bicycle dealer for a free replacement hub.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 16122
Date reported March 16, 2016
Date initiated March 16, 2016
Recalling firm Prodigy Group, of Mooresville, Ind.
Affected scope About 54,000 (In addition, about 2,900 were sold in Canada)
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should immediately stop using bicycles equipped with the recalled front hubs and contact SRAM or local bicycle dealer f…

  • Check the recall number (16122) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
This recall includes SRAM's Zipp bicycle wheel hubs. The model names of the affected hubs are ZIPP 88v6, 88v7 and 88v8. The Z logo is printed on the hub. The wheel hubs come in black, silver and falcon grey. The diameter of the clinch nut is approximately 1.46 inches. Some of the hubs were sold as part of wheel sets installed on new bicycles. SRAM will post a list of affected bicycle brands and models on its website at www.sram.com.. Recalled by Prodigy Group, of Mooresville, Ind.. Units affected: About 54,000 (In addition, about 2,900 were sold in Canada).
Why was this product recalled?
The hub flanges on the front hubs can fail, posing a crash and injury hazard.
What should consumers do?
Consumers should immediately stop using bicycles equipped with the recalled front hubs and contact SRAM or local bicycle dealer for a free replacement hub.
Which agency issued this recall?
This recall was issued by the CPSC on March 16, 2016. CPSC does not publish a hazard classification for this recall. Recall number: 16122.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with Grade A White In-shell Chicken eggs packaged in the followi… → · All Food recalls

This recall: CPSC, reported March 16, 2016. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026