PlainRecalls

Bednest Recalls Bedside Infant Sleepers Due to Fall Hazard (Recall Alert)

Reported: May 10, 2016 Initiated: May 10, 2016 #16743 About 500 units

The recall

Bednest Ltd., of Uk issued this moderate-severity CPSC recall — The bedside sleepers fail to meet mandatory federal requirements for these products, posing a fall hazard to ….

Moderate
severity level
About 500
units affected
May 10, 2016
reported

Sourced from official CPSC enforcement records. Verify recall #16743 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This CPSC action (record #16743) was formally reported on May 10, 2016. It is classified under Moderate severity, with a current status of Active. Bednest Ltd., of Uk is listed as the recalling firm. Federal records indicate About 500 units are affected.

The documented reason for this recall is: The bedside sleepers fail to meet mandatory federal requirements for these products, posing a fall hazard to babies Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled bedside sleeper while the sides are in the fully open position. Bednest is providing a free repair kit that will permanently lock the side rail in… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC and NHTSA going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 10 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Where this recall sits in the database

Severity2119858883High severity (most serious)Moderate severityLow severity
Where this recall sits in the database

Of 83,949 recalls in the database, 21,198 are high severity, 58,883 moderate, and 3,868 low. This recall is classified moderate severity.

Severity

Moderate

Units Affected

About 500

Related Recalls

6

6 from same agency

Product Description

This recall involves Bednest bedside infant sleepers manufactured after July 2014. The date of manufacture is stamped underneath the base of the bedside sleepers. The Bednest has beech wood ends with white fabric sides over metal frames on a beech wood height-adjustable stand. The bedside sleeper measures about 34 inches long by 18.5 inches wide. There are sewn-in Bednest labels on the fabric side panel and on the upper surface of the mattress.

Reason for Recall

The bedside sleepers fail to meet mandatory federal requirements for these products, posing a fall hazard to babies

Remedy

Consumers should immediately stop using the recalled bedside sleeper while the sides are in the fully open position. Bednest is providing a free repair kit that will permanently lock the side rail into place. The firm is contacting all known consumers directly.

Details

Recalling Firm
Bednest Ltd., of Uk
Units Affected
About 500

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 16743
Date reported May 10, 2016
Date initiated May 10, 2016
Recalling firm Bednest Ltd., of Uk
Units affected About 500
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 500 units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves Bednest bedside infant sleepers manufactured after July 2014. The date of manufacture is stamped underneath the base of the bedside sleepers. The Bednest has beech wood ends with white fabric sides over metal frames on a beech wood height-adjustable stand. The bedside sleeper measures about 34 inches long by 18.5 inches wide. There are sewn-in Bednest labels on the fabric side panel and on the upper surface of the mattress.. Recalled by Bednest Ltd., of Uk. Units affected: About 500.
Why was this product recalled?
The bedside sleepers fail to meet mandatory federal requirements for these products, posing a fall hazard to babies
What should consumers do?
Consumers should immediately stop using the recalled bedside sleeper while the sides are in the fully open position. Bednest is providing a free repair kit that will permanently lock the side rail into place. The firm is contacting all known consumers directly.
Which agency issued this recall?
This recall was issued by the CPSC on May 10, 2016. Severity: Moderate. Recall number: 16743.
How do I check if my product is affected by a recall?
Check the product description and recall number (16743) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Infant Walkers Recalled Due to Risk of Serious Injury or De… →

Data Sources

Source: FDA, CPSC, and NHTSA federal recall databases. This recall: CPSC, reported May 10, 2016.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

Source: Federal recall agencies (FDA, CPSC, NHTSA) Aggregated federal recall feeds Recall data normalized across FDA, CPSC and NHTSA feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type).