Cuisinart Food Processors Recalled by Conair Due to Laceration Hazard

Recall Insight

This CPSC action (record #17050) was formally reported on December 13, 2016. It is classified under Moderate severity, with a current status of Active. Conair Corp., of Stamford, Conn., owner of the Cuisinart brand is listed as the recalling firm. Federal records indicate About 8 million (in addition, about 300,000 were sold in Canada) units are affected, placing this recall in the million-unit bracket that typically triggers nationwide consumer alerts and retailer sweeps.

The documented reason for this recall is: The food processor's riveted blade can crack over time and small metal pieces of the blade can break off into the processed food. This poses a laceration hazard to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the food processor's riveted blade and contact Cuisinart for a free replacement blade. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 10 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.