BRP Recalls Can-Am Screw Jacks Due to Crush Hazard

Recall Insight

This CPSC action (record #21054) was formally reported on December 16, 2020. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 650 (In addition, about 54 were sold in Canada) units are affected.

The documented reason for this recall is: The screw jack can collapse and cause the lifted vehicle to fall on a person, posing a crush hazard that can result in severe injury or death. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Customers should immediately stop using the recalled products and contact a BRP Can-Am Off-Road dealer to receive a full refund. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 1 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 6 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.