BlendJet Recalls 4.8 Million BlendJet 2 Portable Blenders Due to Fire and Laceration Hazards

Recall Insight

This CPSC action (record #24069) was formally reported on December 28, 2023. It is classified under Moderate severity, with a current status of Active. BlendJet Inc., of Benicia, California is listed as the recalling firm. Federal records indicate About 4.8 million (in addition, about 117,000 were sold in Canada) units are affected, placing this recall in the million-unit bracket that typically triggers nationwide consumer alerts and retailer sweeps.

The documented reason for this recall is: The recalled blenders can overheat or catch fire and the blender blades can break off, posing fire and laceration hazards to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled blenders and contact BlendJet for a free replacement of the BlendJet 2 base unit. Consumers will need to remove and cut the rubber seal from the b… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 3 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.