Severity
Moderate
CPSC recall · Reported July 31, 2025
The dual action engagement system on the nailers can malfunction and involuntarily discharge a nail by pulling the trigger alone, posing a laceration hazard to consumers. The nail…
The CPSC recalled This recall involves the RIDGID 18Volt Brushless 21-Degree Framing Nailer and the RIDGID … - a moderate-severity action.
TTI Consumer Power Tools Recalls RIDGID Framing Nailers Due to Laceration Hazard was recalled and listed by the CPSC in July 31, 2025. Reason: The dual action engagement system on the nailers can malfunction and involuntarily discharge a nail by pullin…. Remedy: Consumers should immediately stop using the recalled nailers and visit powertools.ridgid.…. Verify recall #25416 with the CPSC before acting.
The recall
issued this moderate-severity CPSC recall-The dual action engagement system on the nailers can malfunction and involuntarily discharge a nail by pullin….
Sourced from official CPSC enforcement records. Verify recall #25416 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
This CPSC action (record #25416) was formally reported on July 31, 2025. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records list the affected scope as About 64,000 (In addition, about 6,575 were sold in Canada).
The documented reason for this recall is: The dual action engagement system on the nailers can malfunction and involuntarily discharge a nail by pulling the trigger alone, posing a laceration hazard to consumers. The nailer should require both the work piece co… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled nailers and visit powertools.ridgid.com/recall to determine if their nailer is included in the recall and for instructions on how to obtain a free… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Where this recall sits in its category - 609 electronics recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Severity
Moderate
Affected scope
About 64,000 (In addition, about 6,575 were sold in Canada)
Related Recalls
6
6 from same agency
This recall involves the RIDGID 18Volt Brushless 21-Degree Framing Nailer and the RIDGID 18Volt Brushless 30-Degree Framing Nailer. The model and serial numbers are located on the data plate found either on the side of the nail tray/magazine where the fasteners are loaded or on the bottom of the nailer where you insert the battery. Only nailers without either a black ink mark or a punched hole next to the serial number on the data plate are included in the recall. Model Number / Name number Serial Number Range R09894 - 18Volt Brushless 21-Degree Framing Nailer CS21146D220001 - CS24165N220001 R09895 - 18Volt Brushless 30-Degree Framing Nailer CS21275D220001 - CS24165N220001
The dual action engagement system on the nailers can malfunction and involuntarily discharge a nail by pulling the trigger alone, posing a laceration hazard to consumers. The nailer should require both the work piece contact element (nose-piece) to be depressed and the trigger to be pulled at the same time in order to discharge a nail.
Consumers should immediately stop using the recalled nailers and visit powertools.ridgid.com/recall to determine if their nailer is included in the recall and for instructions on how to obtain a free repair. TTI Consumer Power Tools will send a prepaid label to the consumer to return the recalled nailer, the software in the nailer will be updated, and then the nailer will be shipped back to the consumer.
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 25416 |
| Date reported | July 31, 2025 |
| Date initiated | July 31, 2025 |
| Recalling firm | Not disclosed |
| Affected scope | About 64,000 (In addition, about 6,575 were sold in Canada) |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should immediately stop using the recalled nailers and visit powertools.ridgid.com/recall to determine if their nailer …
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
Shenzhen Bopu Product Design Co., Ltd., dba POPOOO, of China · 2026-07-02
· 2026-06-25
· 2026-06-25
· 2026-06-25
School Specialty, LLC, of Greenville, Wisconsin · 2026-06-11
Compare this recall with Projecting LED Finger Light Toys Recalled Due to Risk of Se… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported July 31, 2025. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.