DEWALT Recalls Portable Generators Due to Electric Shock Hazard

Recall Insight

This CPSC action (record #07072) was formally reported on January 4, 2007. It is classified under Moderate severity, with a current status of Active. DEWALT Industrial Tool Co., of Towson, Md. is listed as the recalling firm. Federal records indicate About 13,800 units are affected.

The documented reason for this recall is: A ground fault circuit interrupter (GFCI) installed on the generator could fail to operate properly, posing a risk of electric shock to consumers. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the generators immediately and contact DEWALT to arrange for a free inspection and, if necessary, free repair. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 19 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.