PlainRecalls

Marzocchi Recalls Bicycle Forks Due to Crash Hazard and Risk of Injury during Repair

Reported: February 10, 2009 Initiated: February 10, 2009 #09125 About 70 units

Tenneco-Marzocchi s.r.l., of Bologna, Italy issued this CPSC recall on February 10, 2009. Classified as Moderate severity. Approximately About 70 units are affected. The recall was issued because: The suspension system on bikes with the recalled forks could become completely compressed and fail to return to its ori…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #09125) was formally reported on February 10, 2009. It is classified under Moderate severity, with a current status of Active. Tenneco-Marzocchi s.r.l., of Bologna, Italy is listed as the recalling firm. Federal records indicate About 70 units are affected.

The documented reason for this recall is: The suspension system on bikes with the recalled forks could become completely compressed and fail to return to its original position after a forceful landing. This can cause riders to lose control of the bicycle and cr… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using the recalled bicycle forks immediately, and return them to the dealer where purchased for a free repair. Consumers should not attempt to repair the forks. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 17 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 70

Related Recalls

6

6 from same agency

Product Description

The recalled bicycle forks were sold for installation on mountain bikes. The recall involves certain 2008 model year 888RC3 and 888RC3WC suspensions with date codes beginning with T07D07, T07D08 and T07D09. The forks are white or black with red and black artwork on the legs.

Reason for Recall

The suspension system on bikes with the recalled forks could become completely compressed and fail to return to its original position after a forceful landing. This can cause riders to lose control of the bicycle and crash. The forks can also expand forcefully if repair is attempted by the consumer, posing a risk of serious injury.

Remedy

Consumers should stop using the recalled bicycle forks immediately, and return them to the dealer where purchased for a free repair. Consumers should not attempt to repair the forks.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 09125
Date reported February 10, 2009
Date initiated February 10, 2009
Recalling firm Tenneco-Marzocchi s.r.l., of Bologna, Italy
Units affected About 70
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 70 units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
The recalled bicycle forks were sold for installation on mountain bikes. The recall involves certain 2008 model year 888RC3 and 888RC3WC suspensions with date codes beginning with T07D07, T07D08 and T07D09. The forks are white or black with red and black artwork on the legs.. Recalled by Tenneco-Marzocchi s.r.l., of Bologna, Italy. Units affected: About 70.
Why was this product recalled?
The suspension system on bikes with the recalled forks could become completely compressed and fail to return to its original position after a forceful landing. This can cause riders to lose control of the bicycle and crash. The forks can also expand forcefully if repair is attempted by the consumer, posing a risk of serious injury.
What should consumers do?
Consumers should stop using the recalled bicycle forks immediately, and return them to the dealer where purchased for a free repair. Consumers should not attempt to repair the forks.
Which agency issued this recall?
This recall was issued by the CPSC on February 10, 2009. Severity: Moderate. Recall number: 09125.
How do I check if my product is affected by a recall?
Check the product description and recall number (09125) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Aisstxoer Adult Bicycle Helmets Recalled Due to Risk of Ser… →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).