PlainRecalls
No agency classActive

CPSC recall · Reported April 7, 2009

Stanley and Solarwide Industrial Recall Stud Sensors Due to Shock Hazard

The stud sensor can fail to calibrate properly and detect AC electrical wires behind the wall, posing a shock hazard to the user.

Recall #
09185
Affected scope
About 78,000
Verify with CPSC →
View my saved recalls

Solarwide Industrial Ltd., of Hong Kong recalled The recalled stud sensor models include the Stanley® Stud Sensor 200 and Stanley® FatMax®….

Stanley and Solarwide Industrial Recall Stud Sensors Due to Shock Hazard was recalled by Solarwide Industrial Ltd., of Hong Kong in April 7, 2009. Reason: The stud sensor can fail to calibrate properly and detect AC electrical wires behind the wall, posing a shock…. Remedy: Consumers should contact Stanley to determine if their stud sensor is included in the rec…. Verify recall #09185 with the CPSC before acting.

The recall

Solarwide Industrial Ltd., of Hong Kong issued this CPSC recall-The stud sensor can fail to calibrate properly and detect AC electrical wires behind the wall, posing a shock….

None
agency class
April 7, 2009
reported

Sourced from official CPSC enforcement records. Verify recall #09185 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Electronics recalls over time

Where this recall sits in its category - 622 electronics recalls on record

102030405060 20052008201120142017202020232026 49

Product description

The recalled stud sensor models include the Stanley® Stud Sensor 200 and Stanley® FatMax® Stud Sensor 400 with model numbers 77-720 and 77-730. The model number is located in a slide-out reference guide found in the base of the sensor's handle. The sensors are made of black plastic with a wide yellow stripe down the center. "Stanley" or "FatMax" are printed on the front of the product. A date code is printed on the inside of the battery cover. Affected sensors have date codes that do not begin with the letter "R."

Reason for recall

The stud sensor can fail to calibrate properly and detect AC electrical wires behind the wall, posing a shock hazard to the user.

Remedy, what to do

Consumers should contact Stanley to determine if their stud sensor is included in the recall and to receive a free replacement sensor.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 09185
Date reported April 7, 2009
Date initiated April 7, 2009
Recalling firm Solarwide Industrial Ltd., of Hong Kong
Affected scope About 78,000
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should contact Stanley to determine if their stud sensor is included in the recall and to receive a free replacement se…

  • Check the recall number (09185) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
The recalled stud sensor models include the Stanley® Stud Sensor 200 and Stanley® FatMax® Stud Sensor 400 with model numbers 77-720 and 77-730. The model number is located in a slide-out reference guide found in the base of the sensor's handle. The sensors are made of black plastic with a wide yellow stripe down the center. "Stanley" or "FatMax" are printed on the front of the product. A date code is printed on the inside of the battery cover. Affected sensors have date codes that do not begin with the letter "R.". Recalled by Solarwide Industrial Ltd., of Hong Kong. Units affected: About 78,000.
Why was this product recalled?
The stud sensor can fail to calibrate properly and detect AC electrical wires behind the wall, posing a shock hazard to the user.
What should consumers do?
Consumers should contact Stanley to determine if their stud sensor is included in the recall and to receive a free replacement sensor.
Which agency issued this recall?
This recall was issued by the CPSC on April 7, 2009. CPSC does not publish a hazard classification for this recall. Recall number: 09185.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with JINHEZO Mini Waterproof LED Tea Lights Recalled Due to Risk… → · All Electronics recalls

This recall: CPSC, reported April 7, 2009. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026