PlainRecalls
No agency classActive

CPSC recall · Reported June 17, 2009

Wagner Spray Tech Recalls Heat Guns Due to Fire and Burn Hazards

An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior…

Recall #
09243
Affected scope
About 300,000
Verify with CPSC →
View my saved recalls

Wagner Spray Tech Corp., of Minneapolis, Minn. recalled The recalled heat guns emit hot air and are used for paint and flooring removal, defrosti….

Wagner Spray Tech Recalls Heat Guns Due to Fire and Burn Hazards was recalled by Wagner Spray Tech Corp., of Minneapolis, Minn. in June 17, 2009. Reason: An electrical component failure inside the heat guns can cause them to continue to produce heat after the pow…. Remedy: Consumers should immediately stop using the recalled heat guns and contact Wagner for a f…. Verify recall #09243 with the CPSC before acting.

The recall

Wagner Spray Tech Corp., of Minneapolis, Minn. issued this CPSC recall-An electrical component failure inside the heat guns can cause them to continue to produce heat after the pow….

None
agency class
June 17, 2009
reported

Sourced from official CPSC enforcement records. Verify recall #09243 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Food recalls over time

Where this recall sits in its category - 25,457 food recalls on record

01,0002,0003,000 20052008201120142017202020232026 813

Product description

The recalled heat guns emit hot air and are used for paint and flooring removal, defrosting freezers and water lines, bending plastic, hobbies, etc. Recalled models include the Milwaukee Heat Gun MHT3300, ACE HT3500 Heat Gun, and the Wagner Heat Gun HT3500 with date codes V300R through Z365R and A001R through A111R. The heat gun's name and model number are located on a black label on the bottom of the heat gun's barrel. The date code is stamped into the bottom of the handle near the power cord. The heat guns are black or yellow plastic and measure about 10 inches long, 8 inches high and 3 inches wide.

Reason for recall

An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior, causing a burn if the heat gun is touched and ignite nearby combustibles, posing fire and burn hazards.

Remedy, what to do

Consumers should immediately stop using the recalled heat guns and contact Wagner for a free replacement product.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 09243
Date reported June 17, 2009
Date initiated June 17, 2009
Recalling firm Wagner Spray Tech Corp., of Minneapolis, Minn.
Affected scope About 300,000
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Consumers should immediately stop using the recalled heat guns and contact Wagner for a free replacement product.

  • Check the recall number (09243) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
The recalled heat guns emit hot air and are used for paint and flooring removal, defrosting freezers and water lines, bending plastic, hobbies, etc. Recalled models include the Milwaukee Heat Gun MHT3300, ACE HT3500 Heat Gun, and the Wagner Heat Gun HT3500 with date codes V300R through Z365R and A001R through A111R. The heat gun's name and model number are located on a black label on the bottom of the heat gun's barrel. The date code is stamped into the bottom of the handle near the power cord. The heat guns are black or yellow plastic and measure about 10 inches long, 8 inches high and 3 inches wide.. Recalled by Wagner Spray Tech Corp., of Minneapolis, Minn.. Units affected: About 300,000.
Why was this product recalled?
An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior, causing a burn if the heat gun is touched and ignite nearby combustibles, posing fire and burn hazards.
What should consumers do?
Consumers should immediately stop using the recalled heat guns and contact Wagner for a free replacement product.
Which agency issued this recall?
This recall was issued by the CPSC on June 17, 2009. CPSC does not publish a hazard classification for this recall. Recall number: 09243.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with Grade A White In-shell Chicken eggs packaged in the followi… → · All Food recalls

This recall: CPSC, reported June 17, 2009. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026