PlainRecalls
No agency classActive

CPSC recall · Reported July 7, 2009

BioSensory Recalls Dragonfly II Mosquito Trap and NightWatch Bedbug Monitor Products Due to Laceration or Burn Hazard

Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release of CO2. This could cause cracks with sharp edges that could cut a consu…

Recall #
09750
Affected scope
70 Mosquito Traps; and 1500 Bed Bug Monitors
Verify with CPSC →
View my saved recalls

BioSensory, Inc., of Putnam, Conn. recalled The Dragonfly II Model 503 is a cylindrical unit made of metal and plastic with a black, ….

BioSensory Recalls Dragonfly II Mosquito Trap and NightWatch Bedbug Monitor Products Due … was recalled by BioSensory, Inc., of Putnam, Conn. in July 7, 2009. Reason: Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release o…. Remedy: Dragonfly: Consumers should stop using the recalled product immediately and contact Front…. Verify recall #09750 with the CPSC before acting.

The recall

BioSensory, Inc., of Putnam, Conn. issued this CPSC recall-Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release o….

None
agency class
July 7, 2009
reported

Sourced from official CPSC enforcement records. Verify recall #09750 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Medical Devices recalls over time

Where this recall sits in its category - 41,021 medical devices recalls on record

01,0002,0003,0004,000 20052008201120142017202020232026 1,947

Product description

The Dragonfly II Model 503 is a cylindrical unit made of metal and plastic with a black, silver and dark graphite finish. The units are about 36 inches tall and 8 inches in diameter. The Dragonfly logo, model number, electrical information, Canadian Standards Association (CSA) mark for Canada and the United States (C US), BioSensory street and internet address are engraved on the main housing, on the side opposite the control panel. The NightWatch Model 506 is a white molded plastic unit 14 inches long and 6 inches high with a black and white striped thermal lure over the top and sides. Two detachable pitfalls are on either side of the unit. The pitfalls have a felt ramp leading to the elongated collection pit. The NightWatch model number, electrical information, Canadian Standards Association (CSA) mark for Canada and the United States (C US), BioSensory street and internet address are engraved on the underside of the unit beneath the control panel.

Reason for recall

Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release of CO2. This could cause cracks with sharp edges that could cut a consumer's hand, or direct CO2 discharge could cause a frostbite-like burn to a consumer's hand.

Remedy, what to do

Dragonfly: Consumers should stop using the recalled product immediately and contact Frontgate to receive a replacement unit. Night Watch: Professional pest control operators who purchased NightWatch from Residex or Forshaw Distribution should take the units out of service immediately and return them to the distributor center for replacement.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 09750
Date reported July 7, 2009
Date initiated July 7, 2009
Recalling firm BioSensory, Inc., of Putnam, Conn.
Affected scope 70 Mosquito Traps; and 1500 Bed Bug Monitors
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

What to do with this recall

Dragonfly: Consumers should stop using the recalled product immediately and contact Frontgate to receive a replacement unit. Nigh…

  • Check the recall number (09750) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
The Dragonfly II Model 503 is a cylindrical unit made of metal and plastic with a black, silver and dark graphite finish. The units are about 36 inches tall and 8 inches in diameter. The Dragonfly logo, model number, electrical information, Canadian Standards Association (CSA) mark for Canada and the United States (C US), BioSensory street and internet address are engraved on the main housing, on the side opposite the control panel. The NightWatch Model 506 is a white molded plastic unit 14 inches long and 6 inches high with a black and white striped thermal lure over the top and sides. Two detachable pitfalls are on either side of the unit. The pitfalls have a felt ramp leading to the elongated collection pit. The NightWatch model number, electrical information, Canadian Standards Association (CSA) mark for Canada and the United States (C US), BioSensory street and internet address are engraved on the underside of the unit beneath the control panel.. Recalled by BioSensory, Inc., of Putnam, Conn.. Units affected: 70 Mosquito Traps; and 1500 Bed Bug Monitors.
Why was this product recalled?
Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release of CO2. This could cause cracks with sharp edges that could cut a consumer's hand, or direct CO2 discharge could cause a frostbite-like burn to a consumer's hand.
What should consumers do?
Dragonfly: Consumers should stop using the recalled product immediately and contact Frontgate to receive a replacement unit. Night Watch: Professional pest control operators who purchased NightWatch from Residex or Forshaw Distribution should take the units out of service immediately and return them to the distributor center for replacement.
Which agency issued this recall?
This recall was issued by the CPSC on July 7, 2009. CPSC does not publish a hazard classification for this recall. Recall number: 09750.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with GORE VIABIL Short Wire Biliary Endoprosthesis, Model No. VS… → · All Medical Devices recalls

This recall: CPSC, reported July 7, 2009. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026