PlainRecalls

Louis Garneau Recalls Aerodynamic Bicycle Helmets Due to Injury Hazard

Reported: October 10, 2014 Initiated: October 10, 2014 #15005 About 1,180 helmets units

CPSC recall on October 10, 2014. Classified as Moderate severity. Approximately About 1,180 helmets units are affected. The recall was issued because: In cold temperatures, the helmet can fail to protect the wearer from impact injuries.. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #15005) was formally reported on October 10, 2014. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 1,180 helmets units are affected.

The documented reason for this recall is: In cold temperatures, the helmet can fail to protect the wearer from impact injuries. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled helmets and return them to Louis Garneau USA for a refund or replacement with a similar helmet. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 1 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 12 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 1,180 helmets

Related Recalls

6

1 from same agency

Product Description

This recall involves Louis Garneau P-09 aerodynamic bicycle helmets with model number 1405362. The helmets are shaped like tear drops with a rounded front and a short, tapered tail. The outer shells of the helmets are made of polycarbonate and have a built-in visor system, dimples on the top like those on a golf ball, a small rectangular vent in the front and a triangular vent in the rear. The helmets came in three color schemes: black with red and white designs, white with blue and gray designs, and white with silver and white designs. The word "Garneau" is located on both sides of the helmet and the Louis Garneau logo is on the front under the vent. Recalled helmets have the manufacture date "Jan. 2014" on a sticker inside the helmet.

Reason for Recall

In cold temperatures, the helmet can fail to protect the wearer from impact injuries.

Remedy

Consumers should immediately stop using the recalled helmets and return them to Louis Garneau USA for a refund or replacement with a similar helmet.

Details

Units Affected
About 1,180 helmets

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 15005
Date reported October 10, 2014
Date initiated October 10, 2014
Recalling firm Not disclosed
Units affected About 1,180 helmets
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 1,180 helmets units affected — limited or regional distribution scale.

Regional (<10K units) ✓ This recall
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves Louis Garneau P-09 aerodynamic bicycle helmets with model number 1405362. The helmets are shaped like tear drops with a rounded front and a short, tapered tail. The outer shells of the helmets are made of polycarbonate and have a built-in visor system, dimples on the top like those on a golf ball, a small rectangular vent in the front and a triangular vent in the rear. The helmets came in three color schemes: black with red and white designs, white with blue and gray designs, and white with silver and white designs. The word "Garneau" is located on both sides of the helmet and the Louis Garneau logo is on the front under the vent. Recalled helmets have the manufacture date "Jan. 2014" on a sticker inside the helmet.. Units affected: About 1,180 helmets.
Why was this product recalled?
In cold temperatures, the helmet can fail to protect the wearer from impact injuries.
What should consumers do?
Consumers should immediately stop using the recalled helmets and return them to Louis Garneau USA for a refund or replacement with a similar helmet.
Which agency issued this recall?
This recall was issued by the CPSC on October 10, 2014. Severity: Moderate. Recall number: 15005.
How do I check if my product is affected by a recall?
Check the product description and recall number (15005) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Amazon Recalls Amazon Basics Camping Folding Pocket Knives … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).