PlainRecalls

Zebra Technologies Recalls Power Supply Units for Thermal Printers Due to Fire Hazard

Reported: December 20, 2016 Initiated: December 20, 2016 #17056 About 166,000 units

FSP Group, of Taiwan issued this CPSC recall on December 20, 2016. Classified as Moderate severity. Approximately About 166,000 units are affected. The recall was issued because: The power supply units can degrade and corrode over time when exposed to moisture and overheat, posing a fire hazard.. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #17056) was formally reported on December 20, 2016. It is classified under Moderate severity, with a current status of Active. FSP Group, of Taiwan is listed as the recalling firm. Federal records indicate About 166,000 units are affected, a scale large enough to require multi-state distribution tracking.

The documented reason for this recall is: The power supply units can degrade and corrode over time when exposed to moisture and overheat, posing a fire hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Printer owners should immediately stop using the recalled power supply units and contact Zebra for a free replacement power supply. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 10 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 166,000

Related Recalls

6

6 from same agency

Product Description

This recall involves power supply units that serve as the power source for models of Zebra brand thermal industrial printers used to make bar codes and other commercial labels. The power supply units were either sold as after-market kits or included with the sale of the following models of Zebra brand printers: G-Series (GK420D/T, GX420D/T, GX430D/T), GT Series (GT800, GT810, GT820, GT830), ZP455, HC100, P1XX Series (P100, P110, P120), and ZXP3. The Zebra logo or FSP North America logo, date code and part number are printed on the power supply. Date codes between 1039XX through 1052XX and 1101XX through 1152XX are included in the recall for the following power supply units: Printer Model Zebra Power Supply Unit Part Number Power Supply Unit Type GK420d 808099-001 70W Brick GK420t 808099-001 70W Brick GX420d 808101-001 100W Brick GX420t 808101-001 100W Brick GX430d 808101-001 100W Brick GX430t 808101-001 100W Brick GT800 808099-001 70W Brick GT810 808099-001 70W Brick GT820 808099-001 70W Brick GT830 808099-001 70W Brick HC100 808099-003 70W Brick (Medical Brick) P1XX 808099-002 70W Brick ZXP3 808101-001 100W Brick

Reason for Recall

The power supply units can degrade and corrode over time when exposed to moisture and overheat, posing a fire hazard.

Remedy

Printer owners should immediately stop using the recalled power supply units and contact Zebra for a free replacement power supply.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 17056
Date reported December 20, 2016
Date initiated December 20, 2016
Recalling firm FSP Group, of Taiwan
Units affected About 166,000
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 166,000 units affected — multi-state distribution scale.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units) ✓ This recall
Massive (≥1M units)

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves power supply units that serve as the power source for models of Zebra brand thermal industrial printers used to make bar codes and other commercial labels. The power supply units were either sold as after-market kits or included with the sale of the following models of Zebra brand printers: G-Series (GK420D/T, GX420D/T, GX430D/T), GT Series (GT800, GT810, GT820, GT830), ZP455, HC100, P1XX Series (P100, P110, P120), and ZXP3. The Zebra logo or FSP North America logo, date code and part number are printed on the power supply. Date codes between 1039XX through 1052XX and 1101XX through 1152XX are included in the recall for the following power supply units: Printer Model Zebra Power Supply Unit Part Number Power Supply Unit Type GK420d 808099-001 70W Brick GK420t 808099-001 70W Brick GX420d 808101-001 100W Brick GX420t 808101-001 100W Brick GX430d 808101-001 100W Brick GX430t 808101-001 100W Brick GT800 808099-001 70W Brick GT810 808099-001 70W Brick GT820 808099-001 70W Brick GT830 808099-001 70W Brick HC100 808099-003 70W Brick (Medical Brick) P1XX 808099-002 70W Brick ZXP3 808101-001 100W Brick. Recalled by FSP Group, of Taiwan. Units affected: About 166,000.
Why was this product recalled?
The power supply units can degrade and corrode over time when exposed to moisture and overheat, posing a fire hazard.
What should consumers do?
Printer owners should immediately stop using the recalled power supply units and contact Zebra for a free replacement power supply.
Which agency issued this recall?
This recall was issued by the CPSC on December 20, 2016. Severity: Moderate. Recall number: 17056.
How do I check if my product is affected by a recall?
Check the product description and recall number (17056) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with LShome Photoelectric Smoke Detector Fire Alarms Recalled Du… →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).