PlainRecalls

One World Technologies Recalls Electric Blowers Due to Laceration Hazard; Sold Exclusively at Home Depot

Reported: March 2, 2017 Initiated: March 2, 2017 #17101 About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico) units

Techtronic Industries (Dongguan) Co. Ltd., of China issued this CPSC recall on March 2, 2017. Classified as Moderate severity. Approximately About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico) units are affected. The recall was issued because: The plastic fan inside the blower can break causing the fan blades to be discharged from either end of the blower tube,…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #17101) was formally reported on March 2, 2017. It is classified under Moderate severity, with a current status of Active. Techtronic Industries (Dongguan) Co. Ltd., of China is listed as the recalling firm. Federal records indicate About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico) units are affected, placing this recall in the million-unit bracket that typically triggers nationwide consumer alerts and retailer sweeps.

The documented reason for this recall is: The plastic fan inside the blower can break causing the fan blades to be discharged from either end of the blower tube, posing a laceration hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled electric blowers and contact One World Technologies, Inc. for a free replacement. — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 3 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 9 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico)

Related Recalls

6

3 from same agency

Product Description

This recall involves the Ryobi 8amp Electric Jet Fan Blowers with model number RY42102 and a serial number between EU15401D170001 and EU16239N999999. The model and serial numbers are printed on the data label on the bottom of the blower. The blower is black and green with "RYOBI" printed on the side of the blower. "8amp JET FAN" is also printed on the side of the blower.

Reason for Recall

The plastic fan inside the blower can break causing the fan blades to be discharged from either end of the blower tube, posing a laceration hazard.

Remedy

Consumers should immediately stop using the recalled electric blowers and contact One World Technologies, Inc. for a free replacement.

Details

Units Affected
About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico)

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 17101
Date reported March 2, 2017
Date initiated March 2, 2017
Recalling firm Techtronic Industries (Dongguan) Co. Ltd., of China
Units affected About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico)
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico) units affected — million-unit bracket.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units) ✓ This recall

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves the Ryobi 8amp Electric Jet Fan Blowers with model number RY42102 and a serial number between EU15401D170001 and EU16239N999999. The model and serial numbers are printed on the data label on the bottom of the blower. The blower is black and green with "RYOBI" printed on the side of the blower. "8amp JET FAN" is also printed on the side of the blower.. Recalled by Techtronic Industries (Dongguan) Co. Ltd., of China. Units affected: About 121,000 (In addition, about 1,900 were sold in Canada and 1,100 in Mexico).
Why was this product recalled?
The plastic fan inside the blower can break causing the fan blades to be discharged from either end of the blower tube, posing a laceration hazard.
What should consumers do?
Consumers should immediately stop using the recalled electric blowers and contact One World Technologies, Inc. for a free replacement.
Which agency issued this recall?
This recall was issued by the CPSC on March 2, 2017. Severity: Moderate. Recall number: 17101.
How do I check if my product is affected by a recall?
Check the product description and recall number (17101) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Deep-brand PREMIUM Select Fansi Cut French Beans Net Wt. 12… →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).