Vernier Software & Technology Recalls Circuit Boards Due to Burn Hazard (Recall Alert)

Recall Insight

This CPSC action (record #18746) was formally reported on June 6, 2018. It is classified under Moderate severity, with a current status of Active. Charles Assembly, of Aloha, Ore. is listed as the recalling firm. Federal records indicate About 4,200 units are affected.

The documented reason for this recall is: There are two switches on the VCB2 that can get stuck between positions causing the switches to short out and overheat. If the switches overheat, the metal case of the switch can become hot, posing a burn hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled circuit boards and return them to the firm for a free repair. Instructions for returning the units are available on the firm's website. Vernier is… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 8 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.