CHRYSLER 2018: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT

Recall Insight

This NHTSA action (record #18V493000) was formally reported on July 26, 2018. It is classified under Critical severity, with a current status of Active. Chrysler is listed as the recalling firm. The number of affected units is not disclosed in the agency filing, which is common for drug and food recalls where lot-level tracking supersedes unit counts.

The documented reason for this recall is: Chrysler (FCA US LLC) is recalling certain 2018 Chrysler Pacifica vehicles. The front axle halfshafts may have been incorrectly assembled, preventing the shaft from being properly secured to the constant-velocity (CV) … The specific hazard cited in the filing is: If the axle shaft disengages from the CV joint, the vehicle will have a loss of drive or allow the vehicle to move while in the "Park" position. Either condition may increase the risk of a crash.. Distribution data in the federal record shows the product reached: United States. Distribution scope directly affects the consumer exposure window and determines whether a recall remains regional or escalates into a nationwide advisory. The remedy documented by the agency is: Chrysler will notify owners, and dealers will replace the left or right halfshaft assembly, free of charge. The recall began September 18, 2018. Owners may contact Chrysler customer service at 1-80… - consumers holding this product should act on that instruction rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.