PlainRecalls

DeWALT Recalls Nearly 1.4 Million Miter Saws Due to Injury and Laceration Hazards

Reported: August 4, 2022 Initiated: August 4, 2022 #22196 About 1,364,000 (In addition, about 118,600 were sold in Canada) units

CPSC recall on August 4, 2022. Classified as Moderate severity. Approximately About 1,364,000 (In addition, about 118,600 were sold in Canada) units are affected. The recall was issued because: The miter saw's rear safety guard can break or detach, posing an injury hazard due to projectiles that can strike the u…. This recall notice is sourced from official CPSC enforcement records. Below you will find the complete product description, hazard information, remedy instructions, and related recalls from the same manufacturer or product category.

Recall Insight

This CPSC action (record #22196) was formally reported on August 4, 2022. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 1,364,000 (In addition, about 118,600 were sold in Canada) units are affected, placing this recall in the million-unit bracket that typically triggers nationwide consumer alerts and retailer sweeps.

The documented reason for this recall is: The miter saw's rear safety guard can break or detach, posing an injury hazard due to projectiles that can strike the user and bystanders and a laceration hazard to the user who could come into direct contact with the s… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled miter saws and contact DeWALT for details on how to receive a free repair kit or to take their saw to a DeWALT service center for a free repair. D… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC, NHTSA and USDA FSIS going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 4 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.

Recall Distribution by Severity Class

Severity1Class I (Critical)Class II (Moderate)Class III (Low)
Recall Distribution by Severity Class

Severity

Moderate

Units Affected

About 1,364,000 (In addition, about 118,600 were sold in Canada)

Related Recalls

6

6 from same agency

Product Description

This recall involves DeWALT Models DWS779, DWS780 and DHS790 Miter Saws. The saws have a yellow body with black accents and the DeWALT logo. The model number is printed on the saw's nameplate. Only saws with date codes 2019 04 through 2022 04 are affected. For the DWS779 and DWS780 models the date codes are marked on the black plastic motor end cap adjacent to the name plate. For the DHS790 model, the date code is marked on the outside of the plastic yellow housing adjacent to the batteries. Only saws without a green dot on the name plate or a black dot on the arm of the saw are included in this recall.

Reason for Recall

The miter saw's rear safety guard can break or detach, posing an injury hazard due to projectiles that can strike the user and bystanders and a laceration hazard to the user who could come into direct contact with the saw blade.

Remedy

Consumers should immediately stop using the recalled miter saws and contact DeWALT for details on how to receive a free repair kit or to take their saw to a DeWALT service center for a free repair. DeWALT is directly contacting all known purchasers.

Details

Units Affected
About 1,364,000 (In addition, about 118,600 were sold in Canada)

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Moderate
Status Active
Recall number 22196
Date reported August 4, 2022
Date initiated August 4, 2022
Recalling firm Not disclosed
Units affected About 1,364,000 (In addition, about 118,600 were sold in Canada)
Distribution Not disclosed

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

About 1,364,000 (In addition, about 118,600 were sold in Canada) units affected — million-unit bracket.

Regional (<10K units)
Multi-state (10K – 100K units)
Large-scale (100K – 1M units)
Massive (≥1M units) ✓ This recall

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

Frequently Asked Questions

What product was recalled?
This recall involves DeWALT Models DWS779, DWS780 and DHS790 Miter Saws. The saws have a yellow body with black accents and the DeWALT logo. The model number is printed on the saw's nameplate. Only saws with date codes 2019 04 through 2022 04 are affected. For the DWS779 and DWS780 models the date codes are marked on the black plastic motor end cap adjacent to the name plate. For the DHS790 model, the date code is marked on the outside of the plastic yellow housing adjacent to the batteries. Only saws without a green dot on the name plate or a black dot on the arm of the saw are included in this recall.. Units affected: About 1,364,000 (In addition, about 118,600 were sold in Canada).
Why was this product recalled?
The miter saw's rear safety guard can break or detach, posing an injury hazard due to projectiles that can strike the user and bystanders and a laceration hazard to the user who could come into direct contact with the saw blade.
What should consumers do?
Consumers should immediately stop using the recalled miter saws and contact DeWALT for details on how to receive a free repair kit or to take their saw to a DeWALT service center for a free repair. DeWALT is directly contacting all known purchasers.
Which agency issued this recall?
This recall was issued by the CPSC on August 4, 2022. Severity: Moderate. Recall number: 22196.
How do I check if my product is affected by a recall?
Check the product description and recall number (22196) against your product. Visit the official CPSC website for the most current information. You can also use our Recall Checker tool to search by product name or brand.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Recall Context

Product recalls are issued when a manufacturer, distributor, or federal agency determines that a product poses a safety risk to consumers. This recall is classified as moderate severity, indicating the product may cause temporary or medically reversible health consequences. Across PlainRecalls, we track 83,000+ recalls from FDA, CPSC, and NHTSA to help consumers stay informed and act quickly when safety issues arise.

Nearby Recalls in This Category

Other recalls in the same product category — useful for spotting patterns across the same defect class or manufacturer.

Compare this recall with Electrolux Group Recalls Frigidaire Gas Ranges Due to Burn … →

Data Sources

Data as of 2025. Source: FDA, CPSC, NHTSA, USDA FSIS federal recall databases.

  • Source: FDA — Food and Drug Administration, openFDA Enforcement API (food, drug, and medical device recalls)
  • Source: CPSC — Consumer Product Safety Commission Recalls API (consumer product recalls and hazards)
  • Source: NHTSA — National Highway Traffic Safety Administration Recalls API (vehicle safety recalls)
  • Source: USDA FSIS — Food Safety and Inspection Service (meat, poultry, and egg product recalls)

Recall information is sourced from official federal agency databases. Always verify recall details with the issuing agency for the most current status. This information is for research and awareness purposes only.

All federal data sources used on this page

Source: Federal recall agencies (FDA, CPSC, NHTSA, USDA FSIS) Aggregated multi-agency recall feeds · 2024 Recall data normalized across federal agency feeds; severity classifications follow each agency's own taxonomy (FDA Class I/II/III; CPSC, NHTSA, USDA FSIS).