Retrospec Recalls Kid's Bike Helmets Due to Risk of Head Injury; Violation of the Federal Safety Regulation for Bicycle Helmets

Recall Insight

This CPSC action (record #24081) was formally reported on January 11, 2024. It is classified under Moderate severity, with a current status of Active. The recalling firm is not specified in the federal record. Federal records indicate About 72,000 (In addition, 150 in Canada) units are affected, placing this recall in the million-unit bracket that typically triggers nationwide consumer alerts and retailer sweeps.

The documented reason for this recall is: The molded plastic drain pan located at the bottom of the evaporator coil can overheat, melt and deform, posing a fire hazard. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should immediately stop using the recalled helmets and contact Retrospec for a full refund. To receive a refund, consumers should destroy the helmet by cutting off the straps and mark the h… — consumers holding this product should act on that instruction rather than relying on general guidance.

To put this record in context, PlainRecalls indexes 83,949 recalls across the FDA, CPSC and NHTSA going back to 1995. Within the same product category, the database holds 6 closely related recalls, of which 6 were also issued by CPSC. That clustering is a signal — repeated actions in a narrow category often indicate a systemic quality-control issue, a supplier-wide contamination, or a design defect that has propagated across product lines. This recall is roughly 2 years old; older recalls can remain relevant because many units enter resale, rental, and secondary-market channels where the original warning never reaches the end user. Always cross-check the recall number against the official agency page before relying on any summary.